Minka Lavery 4173-249 Instructions / Assembly

INSTALLATION INSTRUCTION FOR 4173-249
WARNING! SHUT POWER OFF AT FUSE OR
CIRCUIT BREAKER.
READ AND SAVE THESE INSTRUCTIONS
ASSEMBLING THE FIXTURE (Fig. 2)
1. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
HANGING THE FIXTURE (Fig. 1)
2. Shut off the power at the circuit breaker and remove old
fixture from ceiling, including the mounting bar.
3. Thread the nipple (E) into the ceiling loop (H) until snug.
4. Thread hex nut (D) onto nipple (E). Place lock washer (C)
over end of nipple (E) .
5. Thread other end of nipple (E) with loop attached into
mounting bar (A) until snug.
6. Take this mounting bar (A) assembly and mount to ceiling
junction box with junction box screws (B). Tighten screws
securely with screwdriver.
7. Using proper chain pliers open one link of chain (I) and
connect it to the fixture loop (J).
8. By measuring, determine connect number of links needed
for proper hanging height.
9. Lace the fixture wires through the chain links, Slip screw
collar ring (G) over the chain, then do the same with the
canopy (F).
10. Open one link of the other end of the chain (I) and connect
it to the ceiling loop (H).
11. Feed the fixture wires through the ceiling loop (H) and
nipple (E) and pull until taut.
CONNECTING THE WIRES (Fig. 3)
12. At this point, connect the electrical wires as shown in
(Fig. 3) making sure all wire nuts are secured. You may
have to wrap the connections with electrical tape. If your
outlet has a ground wire (green or bare copper) connect
fixture’s ground wire to it. Otherwise connect fixture’s
ground wire directly to the mounting bar (A) using the green
screw provided.
13. Tuck these wire connections neatly into the ceiling junction
box and then raise the canopy (F) all the way to the ceiling.
Raise the screw collar ring (G) and thread onto ceiling loop
(H) protruding through canopy (F). (Fig.1)
14. Place the diffuser (O)into the big frame(Q).then place the
small steel sheet (P) of the big frame (Q) onto the diffuser
(O).
15. Place the hook (M) of the decorate frame ( R ) onto the
loop(N).then the loop (L) of the decorate frame ( R ) onto
The hook (K).
16. Install the proper light bulbs for your fixture.
DO NOT EXCEED THE SPECIFIED WATTAGE!
Return the power to the junction box and test the fixture.
Your installation is now complete.
Fig.1
Fig.2