Minka Lavery 4958-267B Instructions / Assembly

INSTALLATION INSTRUCTION FOR 4958
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and
Fig.1
remove the old fixture, including the mounting
hardware.
2. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Position the hanging bracket (B) through the fixing
holes onto the ceiling and make marks, drill pilot
holes for wood screws (D) into the ceiling, then
insert the plastic anchor (A) into the holes.
F
4. Secure hanging bracket (B) to outlet box with
junction box screws (C) (Size:#8-32*0.6”L), then
secure the outlet box with wood screws (D) into
Chain# HCH2072-267B
plastic anchors (A) in the ceiling. The side of the
(3.8mm)
hanging bracket marked “GND” must face out.
HANGING THE FIXTURE (Fig.1)
5. Using proper chain pliers open one link of chains
(H) and connect it to the fixture loops (I).
6. By measuring, determine connect number of links
needed for desired hanging height.
7. Open one link of the other end of the chains (H)
and connect it to the ceiling loops (G).
8. Lace the fixture wires through the chain links (H)
and ceiling loop (G) and pull until taut.
CONNECTING THE WIRES (Fig. 2)
9. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire
(green or bare copper) connect fixture’s ground
wire to it. Otherwise, connect the fixture’s ground
wire directly to the mounting plate using the
green screw provided. After the wires are
connected, tuck them carefully inside the junction
box.
COMPLETING THE INSTALLATION (Fig. 1)
10. Raise the canopy (E) to hanging bracket (B), and
the secure canopy (E) with mounting screws (F)
(Size:#8-32*0.5”L).
11. Place the glass shade (K) and cup (L) over the
socket (J) and secure with the socket ring (M)
with the wrench (N) (provided).
12. Install the light bulb(s) in accordance with the fixture’s
specifications (DO NOT EXCEED THE SPECIFIED
WATTAGE!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!).
Your installation is now complete. Return the power to the
junction box and test the fixture.
Set# A-021-235116
-Hanging bracket
-Ground screw
-Mounting screw*4
-Junction box screw*2
A
B
C
D
E
G
H
I
WRH-T1-51
N
SKT-RING-26
M
L
K
J