Minka Lavery 72383-246 Installation Guide

INSTALLATION INSTRUCTIONS
For Model 72383
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
Fig. 1
1. Shut off the power at the circuit breaker and remove
the old fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Attach the crossbar (C) to the outlet box (A) (not
supplied) with mounting screws (B) (Size:
#8-32*0.78"L)
4. Thread the nipple (E) into crossbar (C). Note: The
length of nipple (E) into crossbar (C) may be adjusted
if necessary.
5. Separate frame (G) from backplate (H) by removing
screws (J),
A
CONNECTING THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in Fig.2
making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly
to the circular strap using the green screw provided.
COMPLETING THE INSTALLATION (Fig. 1)
7. Place the backplate (H) over the nipple (E) and
secure with lock nut (F).
8. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e.
Indoor/Outdoor Silicone Sealant) to outline the
outside of fixture backplate where it meets the wall
leaving a space at bottom to allow moisture a means
to escape. (Fig. 3)
9. Install the bulbs (2 x GU10 35W included.) DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
10. Align frame (G) to backplate (H) and secure with
screws (J).
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Bare
Copper(Gr
ound)
Fig. 3
Your installation is now complete. Return power to the
junction box and test the fixture.
Caulking
Backplate