Minka Lavery 71162-84 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 71162
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
PREPARATION (Fig. 1)
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the old fixture
including the mounting hardware.
2. Carefully remove the new fixture from the carton
and check that all parts are included as shown in
the illustration.
Fig.1
Set# A-022
- Circular strap
- Ground screw
- Mounting screws*2
- Junction box screws*2
MOUNTING THE FIXTURE (Fig.1)
3. Thread the two mounting screws (A) (Size: #832*1.6”L) part way into the circular strap (B).
Secure circular strap (B) to the junction box (not
provided) with junction box screws (C) (Size: #832*0.6”L). The side of the circular strap marked
“GND” must face out. The length of mounting
screws (A) into circular strap (B) may be adjusted
if necessary.
A
B
CONNECTING THE WIRES (Fig. 2)
4. At this point, connect the electrical wires as shown
in Fig. 2 making sure all wire connectors are
secured. If your outlet box has a ground wire
(green or bare copper) connect fixture’s ground
wire to it. Other wise, connect the fixture’s
ground wire directly to the mounting plate using
the green screw provided. After the wires are
connected, tuck them neatly inside the junction
box.
COMPLETING THE INSTALLATION
5. Place the fixture body (D) over mounting screws
(A) and secure with finials (E).
6. Loosen the screws (F), and remove the cup (H).
7. Install the light bulb (not included) in accordance
with the fixture’s specifications (DO NOT
EXCEED THE MAXIMUM WATTAGE!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
8. Place the cup (H) onto the glass (J) and secure
with screws (I).
9. Raise the cup (H) over the socket (G) and secure
with screws (F).
Your installation is now complete. Return the power
to the junction box and test the fixture.
Fig.2