Minka Lavery 5132-84 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 5132
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
READ AND SAVE THESE INSTRUCTIONS
PREPARATION (Fig. 1)
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the old fixture
including the mounting hardware.
2. Carefully remove the new fixture from the carton
and check that all parts are included as shown in
the illustration.
MOUNTING THE FIXTURE (Fig.1)
3. Position the mounting bracket (B) on the wall, and
mark the location of the two dry wall anchors (A).
Pre-drill the holes for the drywall anchors (A) and
insert the drywall anchors (A) into the wall.
4. Attach the mounting bracket (B) to the junction
box using the junction box screws (D) (Size: #832*0.6”L). The side of the mounting bracket
marked “GND” must face out.
5. Place the wood screws (C) through the mounting
bracket (B) and into the drywall anchors (A) to
secure the mounting bracket (B) to the wall.
CONNECTING THE WIRES (Fig. 2)
6. At this point, connect the electrical wires as
shown in Fig. 2, making sure that all wire
connectors are secured. If your outlet box has a
ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting plate
using the green screw provided. After the wires
are connected, tuck them carefully inside the
outlet box.
COMPLETING THE INSTALLATION (Fig. 1)
7. Place the fixture body (F) over the mounting
bracket (B), and secure with mounting screws (E)
(Size:#8-32*0.5”L).
8. Loosen the screws (G), and remove the cups (I).
9. Install the light bulb(s) (not included) in
accordance with the fixture’s specifications (DO
NOT EXCEED THE MAXIMUM WATTAGE!) (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
10. Place the cups (I) onto the glass (K) and resecure with screws (J).
11. Raise the cups (I) over the sockets (H) and
secure with screws (G).
Your installation is now complete. Return the power
to the junction box and test the fixture.
Fig.1
Set# A-021-320102
- Hanging bracket
- Ground screw
- Mounting screws*4
- Junction box screws*2
- Wood screws*2
- Anchors*2
A
B
C
F
D
E
H
G
I
J
K
2