Minka Lavery 8798-161 Installation Guide

INSTALLATION INSTRUCTIONS
Model # 8698/8798
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
MOUNTING THE FIXTURE (Fig.1)
I
J
BA
C
D
K
L
M
G F
H
a(2PCS)
E
b(2PCS)
s
s
a
l
g
c
ON
1. Shut off power at the circuit breaker and remove the
old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to misplace any
small parts necessary for installation.
3. Unscrew the finial (I) with the rubber washer (J),
take apart the back plate (H) apart from the cage
(K).
4. Carefully install the glass sheets (A,B &C) into cage
(K). Secure the glass at the top with long studs (L)
and screws (M). Secure them at the bottom with
short studs (N) and screws (O).
5. Thread the two studs (B) into the pre-drilled holes in
the circular strap (C) spaced the same distance
apart as the holes in the back plate (H), and secure
with the nut (E).
6. Attach the circular strap (C) using outlet box screws
(F) to the outlet box (A), (Fig 1).
Fig. 1
CONNECTING THE WIRES (Fig.2)
Fig.2
7. Connect the electrical wires as shown in Fig.2.
Making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly
to the circular strap using the green screw (D)
provided.
FINISHING THE INSTALLATION
8. Align the back plate (H) to studs (B) and secure with
cap nuts (G). (Fig 1)
9. At this point, install the light bulbs in accordance
with the fixture specification –DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!
10. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone Sealant to
outline the outside of fixture back plate (H) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape.
11. Replace the cage (K) and secure with rubber
washer (J) and finial (I).
Your installation is now complete. Return power to the
outlet box and test the fixture.
FI XTURE
WI RES
GREEN OR
BARE
COPPER
( GROUND)
FI XTURE
WI RES
WHI TE
FI XTURE
WI RES
BLACK
HOUSE
WI RES
BLACK
( HOT)
HOUSE
WI RES
WHI TE
( NEUTRAL)
HOUSE
WI RES
GREEN OR
BARE COPPER( GROUND)
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”