Minka Lavery 3135-298 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR FIXTURE #3135
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (FIG. 2)
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture including the mounting
hardware.
2. Carefully remove the new fixture from the carton and check that
all parts are included as shown in the illustration.
3. Place steel washer (D), plastic washer (M), glass dish (C),
plastic washer (M), steel washer (D) over the nipple (F) in this
order, then secure with hex nut (B).
4. Thread the fixture loop (A) onto the nipple (F) until snug.
5. Place the tube (J) and glass dish (I) over the socket (K).
6. Then install the light bulbs in accordance with fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!) (NE PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
7. Hang the crystal drops (O) & (H) and finial (P) onto the fixture
body as shown in Fig. 2.
8. Hang the crystal chain (L) onto the fixture as shown in Figure 2.
MOUNTING THE FIXTURE (FIG. 1)
1. Thread the nipple (S) into the collar loop (T) until snug.
2. Thread the other end of nipple (S) into the cross bar (P).
3. Place lock washer (Q) and hex nut (R) over the end of nipple (S)
protruding through cross bar (P), then thread hex nut (R) to nipple
(S) until snug.
4. Take this crossbar assembly and mount to ceiling outlet box (V)
using outlet box screw (W). The side of cross bar marked
“GND” must face out.
5. Use proper chain pliers to open one end link of the chain and
connect to the fixture loop (A). Then close the link.
6. By measuring, determine the correct number of links needed for
proper hanging height. Using the chain pliers, disconnect and
discard the remaining chain.
7. Carefully lace the fixture wires through the chain (X).
8. Slip collar ring (Y) over the chain (X), then do the same with
canopy (U).
9. Open the other end link of the chain (X) and connect to the collar
loop (T). Then close the link.
10. Feed the fixture wires through the collar loop (T) and nipple (S)
and pull until tight.
CONNECTING THE WIRES (See Wiring Diagram)
1. At this point, connect the electrical wire as shown in the wiring
diagram, making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare copper),
connect the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting plate using the
green screw provided.
2. Tuck the wire connectors neatly into the ceiling outlet box
and raise the collar ring (Y) and thread onto collar loop (T)
protruding through canopy.
Your installation is now complete. Return power to the outlet box
and test the fixture.
Fig. 2
Fig. 1
Set A#A-010
-Crossbar
-Ground Screw
-Mounting screws (2)
Chain # HCH3072-XX
Gauge 4.5MM
Notice: It is important to use proper chain pliers (not
included) to OPEN and CLOSE the chain included with
this fixture. Do not open them with other tools that may
twist or stress the chain links. It is important to use
proper chain pliers like the ones shown in the diagram.