Minka Lavery 6962-284 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR FIXTURE 6962
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture from wall including
the mounting hardware.
2. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Thread the nipple (C) into the mounting strap (A).
4. Place the washer (F) over the nipple protruding
through the mounting strap and thread lock nut (E)
tightly onto nipple (C).
5. Attach the mounting strap (A) to the outlet box using
the outlet box screws (B). The side of the mounting
plate marked “GND” must face out.
6. Follow the wiring instructions carefully (See Fig.2).
7. Attach the fixture back plate (L) over the mounting
strap (A) allowing the nipple (C) to protrude through
the center hole of the back plate (L). Then secure with
hex nut (M) and finial (K).
8. Place the glass shade (I), and cushion ring (H) over
the socket (J) and secure with socket ring (G).
9. Install the bulbs in accordance with fixture’s
specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
Wiring (See fig.2)
1. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
or bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to
the mounting strap using the green screw provided.
2. Tuck the wire connections neatly into the wall junction
box.
Your installation is now complete. Return power to the
outlet box and test the fixture.
Set A#A-010
-Crossbar
-Ground screw
-Mounting screws (2)
Fig.1
Fig.2
Socket Ring#SKT-RING-26