Minka Lavery 4235-288 Installation Guide

INSTALLATION INSTRUCTIONS FOR 4235-288
WARNING!
SHUT
POWER OFF
AT
FUSE
ASSEMBLING THE FIXTURE (Fig.2)
1. Return the five arms to suitable position, see figure.2.
2. Attach the top of the arm (E) to the fixture body (D) with the ball
screw (B) aligning the hole of the top of the arm (E).
3. Attach the loop (A) to the fixture body (D) by turning it clock
wise until tight.
4. Install a light bulb in accordance with the fixture’s specifications
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!)
5. Place the glass shade (C) into the metal trim of the arm (E).
HANGING THE FIXTURE (Fig.1)
Fig.1
Shut off the power at the circuit breaker and remove old fixture from
ceiling, including the old crossbar.
2. Carefully unpack new fixture and lay all the parts on a clear surface.
3. Thread nipple (C) into loop (F) until snug.
4. Thread other end of nipple (C) with loop attached into crossbar (D)
until snug.
5. Place lock washer (B) over end of nipple protruding through
crossbar and thread hex nut (A) onto nipple until tight.
6. Take this crossbar assembly and mount to ceiling junction box with
junction box screws (E). Tighten screws securely with screwdriver.
7. Using proper chain pliers to open one end link of the chain provided
and connect to the fixture loop (J). Close the link.
8. By measuring, determine correct number of links needed for proper
hanging height. Using proper chain pliers disconnect and discard
remaining chain.
9. Lace the fixture wires through the chain.
10. Slip loop collar (H) over the chain, then do the same with the canopy
(G).
11. Open the other end link of the chain and hang the fixture on the loop
at the ceiling. Close the link.
12. Feed the fixture wires through the loop (F) and nipple (C) and pull
until taut.
OR CIRCUIT BREAKER .
1.
Fig.2
CONNECTING THE WIRES (Fig.3)
1.
Take the black wire from the ceiling junction box and the smooth
wire leg from the fixture and twist bare ends together. Twist wire
connector onto end of wire until snug.
2. Repeat same process with white junction box wire and ribbed wire
leg of fixture wire. NOTE: Twist wires together in the same direction
you twist the wire connector onto wires.
3. If your junction box has a grounding wire (green or bare copper),
attach this wire and the bare copper wire from the fixture together as
step 1.If junction box has no ground wire, attach the bare copper
fixture wire to the green ground screw on the crossbar.
4. Tuck these wire connections neatly into the ceiling outlet box and
then raise the canopy (G) all the way to the ceiling. Raise the loop
collar (H) and thread into ceiling loop protruding through canopy.
Your installation is now complete. Return power to the junction box
and test the fixture.
Fig.3
FI XTURE
WI RES
Bl ack or
Smoot h
HOUSE
WI RES
Bl ack
( Hot )
FI XTURE
WI RES
Whi t e or
Ri bbed
FI XTURE
WI RES
Bar e
Copper
HOUSE ( Gr ound) HOUSE
WI RES
WI RES
Gr een or
Whi t e
Bar e Copper ( Gr ound)
( Neut r al )
CHAIN HUNG FIXTURE INSTRUCTION
Notice: It is important to use proper chain pliers (not
included) To OPEN and CLOSE the chain included with this
fixture. Do not open them with other tools that may twist or
stress the chain links. It is important to use proper chain
pliers like the ones shown in the diagram.