Minka Lavery 4462-84 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 4462-273
READ AND SAVE THESE INSTRUCTIONS
WA R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
MOUNTING THE SQUARE STRAP (Fig.1)
1.
Fig.1
Shut off the power at the circuit breaker and remove old
fixture, including the crossbar.
2.
Carefully unpack your new fixture and lay out all the parts on
a clear area. Take care not to lose any small parts necessary
for installation.
3.
Attach Square Strap (A) to the outlet box using two outlet box
Screws (B). The side of the Square Strap marked “GND”
must face out.
CONNECTING THE WIRES (Fig. 2)
4.
At this point, connect the electrical wires as follow, Connect
the black wire from the fixture to the black house (hot) wire.
Connect the white wire from the fixture to the white (neutral)
house wire. Make sure all wire nuts are secured. You may
wrap the connections with electrical tape. If your outlet box
has a ground wire (green or bare copper) connects fixture’s
ground wire to it. Otherwise connect fixture’s ground wire
directly to the crossbar using the green screw provided.
FINISHING THE INSTALLATION (Fig. 1)
5.
After the wires are connected, tuck them carefully inside the
outlet box as you holding the backplate (E) onto the Square
Strap (A). Adjust the hole of the Square Strap (A) and the
backplate (E) to align the holes, then secure them by
threading the two Allen Screws (D) with wrench (C) until
snug.
6.
Install the bulb in accordance with the fixture’s specification.
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!!)
7.
Put the glass (F) over the socket and twist to secure it to the
fixture.
Your installation is now complete. Return power to the
junction box and test the fixture.
GND