Minka Lavery 2902-613-L Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 2902-613-L
For LED Wall Mount Fixture
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AV E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O D I S J O N C T E U R .
MOUNTING THE FIXTURE (Fig. 1)
1.
2.
3.
4.
5.
Shut off power at the fuse box or circuit breaker box. If necessary
remove the existing fixture and its mounting hardware from the
wall.
Carefully remove the new fixture from the carton and check that
all parts are included as shown in the illustration.
Position mounting plate (A) on the wall, and mark the location of
the two drywall anchors (G). Pre-drill the holes for the drywall
anchors (G), then Insert the drywall anchors (G) into the wall.
Attach the mounting plate (A) to the outlet box using outlet box
screws (B) (Size: 8-32*1/2’’L). The side of the mounting plate
marked “GND” must face out.
Place the wood screws (F) through the holes in the mounting
plate (A) and into the drywall anchors (C) to secure the mounting
plate (A) to the wall.
CONNECTION THE WIRES (Fig. 2)
6.
Connect the electrical wires as shown in Fig.2, making sure that
all wire connectors are secured. If your outlet has a ground wire
(green or bare copper), connect the fixture's ground wire to it.
Otherwise, connect the fixture's ground wire directly to the
mounting plate (A) using the green screw provided. After the
wires are connected, tuck them neatly into the outlet box.
Fig.1F
Fig. 2
FINISHING THE INSTALLATION (Fig. 1)
7.
Align the fixture (E) over mounting plate (A) and secure with
screws (D).
Your installation is now complete. Return power to the outlet box and
test the fixture.
CAUTION /ATTENTION: When handling the fixture, do not apply
pressure to the LEDs. Hold the fixture by the base or fixture body
(E) only.
Fig.3
Replacing LED module (Fig.3)
The LED module can be replaced by a qualified electrician without
cutting the wire and without damaging the decorative element to
which the fixture is attached. See installation steps for more details
(Fig 3.)
Warning: Turn off power at the fuse box or circuit breaker
before replacing the LED module.
a.
To remove the fixture from the wall: loosen screws (D), and
remove the wire connectors. Then place the fixture on a clear
flat surface.
b.
Loosen screws (P) and remove frame (L) and glass shade (K).
c.
Loosen screws (J), screws (M), wire fastener (N) and carefully
remove LED module (I). Reverse steps a-c for installing the new
LED module.
d.
Reverse steps a-c for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
II 782
IMPORTANT: Fixture should be installed by a
qualified electrician to ensure proper wiring and
installation.
Dimmable with C-L (CFL & LED) type and
Incandescent/Halogen type dimmers