Smart Solar 3960KR1 Instructions / Assembly

Performance
Position
û
ü
Summer
Autumn
Winter
1-3h
3-6h
1-3h
0-1h
Position the light to receive the
maximum amount of sunlight.
Light run time
û
Spring
Do not position near bright light as this will
prevent the light switching on at night.
Battery
First use
<50%
48h
Whilst there may be some initial charge in the battery we recommend fully
charging it before first use. Leave the switch in the off position for 2 sunny
days to ensure the battery is fully charged. Once fully charged switch to
“ON” and your light will come on automatically at night.
Rechargeable batteries become less efficient with repeated charge-discharge cycles and
the battery capacity reduces. If you find that the battery appears to be less efficient or
does not run for long we first suggest you try to boost charge it. Leave in the off position
for 3 to 5 sunny days to allow the maximum charge to the battery. If after this boost
charge your battery still does not perform to expectations you should replace it. All our
batteries are covered by a 1 year warranty.
100%
2
3
Change Battery
solar san rafael II lantern
x2
Introduction
Solar Lights work by using electricity generated by the solar panel to charge internal
batteries. These batteries are then used to power the light. When switched on the lights
automatically illuminate at night by using a light sensor. The duration of illumination will
depend on the amount of sunlight and therefore charge received by the batteries.
x2
Replace with 2 x AAA Ni-MH 1.2V
Contents
Battery Disposal
ü
Ni-MH
400mAh
Dispose of battery according to local regulations
Problem Solving
ON
1.
2.
3.
OFF
Check solar panel is positioned correctly
Check the battery and boost charge as described
If problems persist contact customer services
1 Year Warranty
USA
Email: ussupport@smartsolar.com
Tel: +1 813 343 5775
www.smartsolar.com
4
© Smart Solar Ltd. 3901E v1.0
1