the great outdoors by Minka Lavery 72434-261 Instructions / Assembly

INSTALLATION INSTRUCTIONS
WARNING! SHUT
Item#72434-261
READ AND SAVE THESE INSTRUCTIONS
POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
Carefully unpack new fixture and lay all the parts on a clear surface.
1. Attach fixture loop (I) by screwing to nipple. (J)
2. Insert front glass (N) into door (M) and secure with clips (O).
3. Insert back glass (P) and side glass (Q) into lamp body (K), and
secure with clips (L).
`
Fig.1
HANGING THE FIXTURE (Fig.1)
1.
Shut off the power at the circuit breaker and remove the old
fixture from the ceiling, including the mounting hardware.
2. Thread nipple (C) into loop (F) until snug.
3. Thread the other end of nipple (C) with loop attached into
crossbar (D) until snug.
4. Place lock washer (B) over the end of the nipple protruding
through the crossbar and secure with hex nut (A).
5. Attach the crossbar assembly and mount to junction box with
junction box screws (E) (Size: #8-32N*L0.5”).
6. Using proper chain pliers to open one end link of the chain
provided and connect to the fixture loop (I). Close the link.
7. Lace the fixture wires through the chain.
8. By measuring, determine the correct number of links needed
for proper hanging height. Remove and discard remaining
chain.
9. Slip loop collar (H) over the chain, followed by canopy (G).
10. Open the other end link of the chain and hang the fixture on the
loop at the ceiling. Close the link.
11. Feed the fixture wires through loop (F) and nipple (C).
Set# A-016
- Crossbar
- Ground Screw
- Mounting Screw*2
Fig.2
CONNECTING THE WIRES (Fig.3)
12. At this point, connect the fixture wires as shown in
Fig.3, making sure that all wire connectors are secured.
If your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to
the Crossbar (D) using the green screw provided.
4.
Tuck the wire connections neatly into the ceiling outlet
box and then raise the canopy (G) to the ceiling and
secure with loop collar (H) to chain loop (F)l
5.
Install the light bulbs (not included) in accordance with the
fixture’s specifications: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the junction box
and test the fixture.
Note: Illustration (Fig.1) (Fig.2) on this manual is for
installation purposes only. It may or may not be identical
to the fixture purchased.
Chain # HCH2072-261
Gauge D3.8mm
Fig.3
CHAIN HUNG FIXTURE INSTRUCTION
Notice: It is important to use proper chain pliers (not included) To
OPEN and CLOSE the chain included with this fixture. Do not open
them with other tools that may twist or stress the chain links. It is
important to use proper chain pliers like the ones shown in the
diagram.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
HOUSE (Ground) HOUSE
WIRES
WIRES
Green or
White
Bare Copper(Ground)
(Neutral)
CM
C
US
lntertek