World Imports WI260606 Installation Guide

ASSEMBLY AND INSTALLATION (Continued)
4.
Place the FIXTURE PAN (12) of the fixture over the OUTLET BOX (1) so that
the NIPPLE (4), protrudes out through the mounting hole located in the center of
the FIXTURE PAN (12) 1/ 4”. Remove the FIXTURE PAN (12) and secure the
position of the NIPPLE (4) by tightening the 1/8” IPS HEX NUT (5) against the
MOUNTING BRACKET (2). Place the FIXTURE PAN (12) back onto the
NIPPLE (4), and secure into place using the DECORATIVE NUT (20).
5.
Screw light bulbs into the lamp socket and make sure they do not exceed the
maximum wattage specified on the fixture’s wattage rating label.
6.
Place the ARM (14) over the FIXTURE PAN (12) & PLATE (16) and secure in
place using the SCREWS (15) through the hole in the FIXTURE PAN (12) &
PLATE (16) and tightening by screwing into the EYELET (22). Feed the
NIPPLE & BALL (17) through the PLATE (16). Feed the BOTTOM COVER
(18) onto the NIPPLE & BALL (17), and secure it in place using the BOTTOM
FINIAL (19).Install the CRYSTAL LINE (13) as shown below.
FLUSH MOUNT FIXTURE
INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later
date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to
prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical
Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring
connections obtain the services of a qualified electrician.
INSTALLATION IS NOW COMPLETED
Remove the fixture and the mounting package from the box and make sure that no
parts are missing by referencing the illustrations on the installation instructions.
ASSEMBLY AND INSTALLATION
1.
Thread the 1/8 IPS HEX NUTS (5) onto the NIPPLE (4) and screw the
NIPPLE (4) onto the MOUNTING BRACKET (2). Without tighten the 1/8
IPS HEX NUTS (5) at this time.
2.
Pull the SUPPLY WIRES (6 & 7) and the HOUSE GROUND WIRE (8) out
from the OUTLET BOX (1) and attach the MOUNTING BRACKET (2) to
the OUTLET BOX (1) using the slotted holes on the MOUNTING
BRACKET (2) and the #8-32 IPS MOUNTING SCREWS (3) provided.
3.
Attach the power supply wire to the fixture lead wires by connecting the
BLACK SUPPLY WIRE (6) to the BLACK FIXTURE WIRE (10) ,and the
WHITE SUPPLY WIRE (7) to the WHITE FIXTURE WIRE (9) using
WIRE CONNECTORS(21). Connect the remaining HOUSE GROUND
WIRE (8) to the FIXTURE GROUND WIRE (11) using a WIRE
CONNECTOR (21) (not included). Place wiring and connections inside the
OUTLET BOX (1).
1. OUTLET BOX
2. MOUNTING BRACKET
3. MOUNTING SCREW
4. NIPPLE
5. 1/8 IPS HEX NUT
6. BLACK SUPPLY WIRE
7. WHITE SUPPLY WIRE
8. HOUSE GROUND WIRE
9. WHITE FIXTURE WIRE
10. BLACK FIXTURE WIRE
11. FIXTURE GROUND WIRE
12. FIXTURE PAN
13. CRYSTAL LINE
14. ARM
15. SCREW
16. PLATE
17. NIPPLE & BALL
18. BOTTOM COVER
19. FINIAL
20. DECORATIVE NUT
21. WIRE CONNECTOR
22. EYELET