FLUSH MOUNT FIXTURE

INSTALLATION INSTRUCTIONS

5.

6.

ASSEMBLY AND INSTALLATION (Continued)

Carefully tuck all wiring back into the OUTLET BOX (1). Place the COVER PLATE (12) back onto the #8-32 IPS FIXTURE SCREWS (4) and secure the COVER PLATE (12) into place using the DECORATIVE NUTS (14) provided.

Install the bulbs. (See markings and/or labels on the fixture for maximum wattage — DO

NOT OVER LAMP.).Slide the GLASS PANELS(17) into the provided channels on the

CAGE(15).Secure them into place using the GLASS CLIPS(16).

Please read carefully and save these instructions, as you may need them at a later date.

CAUTION

Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.

GENERAL

All electrical connections must be in accordance with local and National Electrical Code

(N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.

Remove the fixture and the mounting package from the box and make sure that no parts are missing by referencing the illustrations on the installation instructions.

ASSEMBLY AND INSTALLATION

1. Screw the #8-32 IPS FIXTURE SCREWS (4) onto the MOUNTING BRACKET (2), and thread the #8-32 HEX NUTS (13) onto the #8-32 FIXTURE SCREWS (4). Do not tighten the #8-32 IPS HEX NUTS (13) at this time.

2. Pull the SUPPLY WIRES (5 & 6) and the SUPPLY GROUND WIRE (7) out from the

OUTLET BOX (1) and attach the MOUNTING BRACKET (2) to the OUTLET BOX (1) using the slotted holes on the MOUNTING BRACKET (2) and the #8-32 IPS

MOUNTING SCREWS (3) provided.

3.

Place the COVER PLATE (12) over the OUTLET BOX (1) and onto the #8-32 IPS

FIXTURE SCREWS (4) and adjust the #8-32 IPS FIXTURE SCREWS (4) until they protrude out from the COVER PLATE (12) 1/4". Remove the COVER PLATE (12) and secure the position of the #8-32 IPS FIXTURE SCREWS (4) by tightening the #8-32 IPS

HEX NUTS (13) against the MOUNTING BRACKET (2).

4.

Attach the BLACK SUPPLY WIRE (6) to the BLACK (or SMOOTH) FIXTURE WIRE

(8) by using the WIRE CONNECTOR (11). In the same manner, attach the WHITE

SUPPLY WIRE (5) to the WHITE (or RIBBED) FIXTURE WIRE (9). Connect the

FIXTURE GROUND WIRE (10) to the SUPPLY GROUND WIRE (7) using a WIRE

CONNECTOR (11)(not included) .

INSTALLATION IS NOW COMPLETED

15

14

16

17

1. OUTLET BOX

2. MOUNTING BRACKET

3. #8-32 IPS MOUNTING SCREW

4. #8-32 IPS FIXTURE SCREW

5. WHITE SUPPLY WIRE

6. BLACK SUPPLY WIRE

7. SUPPLY GROUND WIRE

8. BLACK(or smooth) FIXTURE WIRE

9. WHITE(or ribbed) FIXTURE WIRE

10. FIXTURE GROUND WIRE

11. WIRE CONNECTOR

12. COVER PLATE

13. #8-32 IPS HEX NUT

14. DECORATIVE NUT

15. CAGE

16. GLASS CLIP

17. GLASS PANEL