ASSEMBLY AND INSTALLATION
INSTRUCTIONS
LK48614
AVOID RISK OF ELECTRICAL SHOCK. BE SURE TO SHUT OFF
WARNING: TO
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1.Before installing, consult local electrical codes for wiring and grounding requirements.
2.The combined weight of your ceiling fan and light kit can not exceed 35 pounds unless
additional support is provided for the fan.
Fig.1
Motor
Nipple-1
Switch Box
Hex Nut
Screw
Plug
Nipple-1
Fig.2
Screw
Wire Nut
Lamp Plate
Wire Nut
Washer
Hex Nut
Switch Box cover
Light kit
Nipple
Motor
Switch Box
Terminal(Groove)
Glass Shade
Terminal(Tongue)
Cap Screw
Set Screw
Nipple-1
Switch Box cover
Metal Washer
Cap
Light kit
Pull Chain for Fan
Rubber Washer
Hex Nut
Cap
Pull Chain
Finial
Installation Steps
1. Remove the switch box cover from the fan by loosing 3 screws.
2. Unscrew and discard the plug from the switch box cover.
3. Attach the light kit to the switch box cover.
***For fans of the Fig.1, please attach the nipple-1 of the light kit to the hole of the switch
box cover, and then thread the wires through the washer and hex nut, and secure tightly.
***For fan as Fig.2: Unscrew the cap screw to remove the cap from the light kit, then
secure it upward to the switch box cover using the set screws (6x32 20mmL). Thread
the wires of the light kit through the cap and switch box cover. Attach the light kit to
the cap using the cap screw.
4. Make wire connections with the wire nuts:
---Connect black wire from light kit to blue wire from the fan.
---Connect white wire form light kit to white wire from the fan.
Carefully tuck wires back into the switch box cover.
5. Reinstall the switch box cover with the 3 screws.
6. Install bulbs.( Please do not exceed the maximum capacity which is recommended on the
package.)
7. Thread the pull chain through the glass shade, rubber washer, metal
washer and hex nut in order, and secure with the hex nut to the nipple.
8. Thread the pull chain through the cap and finial, and secure with the finial to the nipple.
9. Thread the pull chain of the fan through the glass shade and the cap.
*** Make sure the hole of glass shade and the hole of the cap for fan was match.
10. Turn on the power at fuse or circuit box.
070424
TM