AireRyder LK33352OBB-C Instructions / Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
LK33312 / LK33352 / LK40112
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless
additional support is provided for the fan.
Motor
Black or Blue Wire
Wire Nut
Black
Switch Box
White Wire
White Wire
Hex Nut & Washer
Switch Box Screw
Center Plug
Switch Box Cover
Nipple(-a)
Cap(-a)
Glass Shade
Cap(-b)
Nipple(-b)
Collar
Cap(-c)
Finial
Pull Chain
For Light Kit:
1. Remove the switch box cover from the switch box of the fan by loosing the three switch box screws.
2. Unscrew the center plug from the switch box cover and discard it.
3. Thread the fixture wire through the switch box cover.
4. Attach the switch box cover to cap(-a), then secure it with a washer and hex nut.
5. Pull out the wires from the switch box. Make wire connections using the wire nuts:
---The black wire from the fixture to the black (or blue) wire from the switch box.
---The white wire from the fixture to the white wire from the switch box.
Carefully tuck the wires back into the switch box.
6. Attach the switch box cover back to the switch box using the three switch box screws.
7. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
8. Thread the pull chain through the glass shade and the collar, then attach the glass shade to cap(-b)
by inserting nipple(-b) and secure it with the collar. Thread the pull chain through cap(-c) and the
finial, then attach cap(-c) to the glass shade and secure it with the finail.
9. Turn on the power at the main fuse or circuit breaker box. (You can control the light with the pull chain.)
TM
LK33312 / LK33352 / LK40112 --- Page 1
060218
For Ceiling Light: (See Fig.1)
1. Take out the canopy set from the hardware package for
ceiling light.
2. Thread the fixture wires through the canopy set. Secure
the canopy set onto nipple(-a) by using the coupling.
4. Attach two screws to the mounting strap, then secure
them with two lock nuts. Adjust the length of the screws
if necessary.
5. Attach the mounting strap to the outlet box by using
two mounting screws.
6. Pull out the outlet wires and the house grounding wire
from the outlet box. Make wire connections using the
wire nuts:
---The black wire from fixture to the black wire from the
outlet box.
---The white wire from fixture to the white wire from the
outlet box.
---Attach the fixture grounding wire to the mounting strap
with the green grounding screw. Then connect it to the
house grounding wire with a wire nut.
Carefully tuck the wires back into the outlet box.
7. Attach canopy to the mounting strap by inserting the
screws, then secure them with the bolt nuts.
8. Follow steps 7~9 as for Light Kit.
Mounting Parts for Ceiling Light
Outlet Box
House Grounding Wire
Wire Nut
Screw
Mounting Strap
Lock Nut
Green Grounding Screw
Mounting Screw
Fixture Grounding Wire
Canopy Set
Bolt Nut
Coupling
Nipple(-a)
Cap(-a)
Fig.1
TM
LK33312 / LK33352 / LK40112--- Page 2
060218