AireRyder LK34244WP-C Instructions / Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
LK34233 / LK34244
TO AVOID RISK OF ELECTRIC SHOCK. BE SURE TO SHUT
OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
WARNING:
NOTE: 1.Before installing, consult local electrical codes for wiring and grounding requirements.
2.The combined weight of your ceiling fan and light kit can not exceed 35 pounds unless
additional support is provided for the fan.
Fig.1
Motor
Switch Box
Hex Nut
Screw
Plug
Nipple
Wire Nut
Washer
Switch Box cover
Switch Box cover
Light kit
Nipple
Plate
Fig.2
Screw
Wire Nut
Motor
Switch Box
Terminal(Groove)
Terminal(Tongue)
Switch Box cover
Set Screw
Screw-1
Lamp Holder
Holder Screw
Glass Shade
Nipple
Plate
Set Screw
Fixture
Screw-1
Installation Steps
1. Remove the switch box cover from the fan by loosing 3 screws.
2. Unscrew and discard the plug from the switch box.
3. Attach the light kit to the switch box cover.
***For fans of the Fig.1, attach the nipple of the light kit to the hole of the
switch cover, and then thread the wires through the washer and hex nut,
secure tightly.
***For fans of the Fig.2, unscrews the 3 screw-1 of the light kit, remove the plate from
the light, attach the nipple to the central hole of the switch box cover, and then
attach the plate to switch box cover with 2 set screws, install the light fixture to
the plate with 3 screws-1.
4. Make wire connections with the wire nuts:
---Connect black or blue wire from light kit to blue wire from the fan.
---Connect white wire form light kit to white wire from the fan.
Carefully tuck wires back into the switch box cover.
5. Reinstall the switch box cover with 3 screws to the fan, attach the glass shade to
the lamp holders, and then secure 3 holder screws of the lamp holder .
6. Install bulbs.( Please do not exceed the maximum capacity which is recommended
on the package.)
7. Turn on the power at fuse or circuit box.