Hampton Bay EW0374CH Installation Guide

WALL FIXTURE
Instruction Manual
Please read carefully and save these instructions, as you may need them at a later date.
SAFETY
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER
THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS TURNED OFF. TURNING THE POWER OFF
USING THE LIGHT SWITCH IS NOT SUFFICIENT TO PREVENT ELECTRICAL SHOCK.
NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all
possible conditions or situations that may occur. It must be understood that common sense, caution,
and care, are factors which cannot be built into any product. These factors must be supplied by the
person(s) installing this unit.
READ & SAVE THESE INSTRUCTIONS
CAUTION: Before assembling the lighting fixture, refer to the section titled Wiring Connections. If you
feel you do not have enough electrical wiring experience, either refer to a do-it–yourself wiring
handbook or have your lighting fixture installed by a qualified, licensed electrician.
UNPACK THE PACKAGE
Check the contents to be sure everything is included
Tools Needed: Slotted screwdriver, Adjustable wrench, Step ladder, Wire cutters, Wiring supplies as
required by electrical code.
INSTALLATION & OPERATION INSTRUCTIONS
GENERAL
Before starting the installation, disconnect the power by turning off the circuit breaker or by removing
the appropriate fuse at the fuse box. Turning the power off using the light switch is not sufficient to
prevent electrical shock.
All electrical connections must be in accordance with local and National Electrical Code (NEC)
standards. If you are unfamiliar with proper electrical wiring connections, obtain the services of a
qualified electrician.
Remove the fixture and the mounting packages from the box and make sure that no parts are missing
by referencing the illustrations on the installation instructions.
Be sure to read these installation instructions and review the diagrams thoroughly before installation.
1
Assembly and Installation
1. Secure the mounting plate (5) to the outlet box (1) using the screws (6) provided.
2. Wiring Connections: Connect the white wire(s) from the fixture to the white wire of the supply circuit. Connect the black wire(s)
from the fixture to the black wire of the supply circuit. Connect the green or bare copper wire to the ground wire of the supply
circuit. Use UL/CSA listed wire connectors suitable for the size type, and number of conductors. No loose strands or loose wires
should be present. Secure wire connectors with UL/CSA listed electrical tape.
3. Place back plate (8) onto screw (7) through the holes on back plate (8) and then secure with finial (9). Adjust screw (7)
length as needed.
4. Place the shade (12) on the socket (13), Tighten the socket ring (11) to secure the shade (12) on to socket (13).
5. Screw the bulb (10) into the socket (13).
Re-lamping
1.
2.
3.
4.
Turn off the lamp at the switch and the main power supply.
Allow the fixture and bulb to cool before touching.
Remove the old bulb and insert a new bulb into the socket.
Restore the main power and turn on at the switch to check the operation of the bulb.
CAUTION: Refer to the re-lamping label near the lamp holder for recommended bulb type and
maximum wattage allowed (bulbs sold separately).
1. Junction Box
2. Wire Connector
3. Ground Wire
4. Ground Green Screw
5. Mounting Plate
6. Screw
7. Screw
8. Back plate
9. Finial
10. Bulb
11. Socket Ring
12. Shade
13. Socket
2