Hampton Bay 21351-013 Installation Guide

TROUBLESHOOTING:
Bulb will not light
Fuse blows or circuit
breaker trips when light
is turned on
Possible Cause
Corrective Action
1. Bulb is burned out
1. Replace light bulb
2. Switch is off
2. Make sure switch is on
3. Faulty wire connection
3. Check wiring
Crossed wires or power
wire is grounding out
Check wire connections
INSTRUCTION MANUAL
INTERIOR 1-LIGHT WALL SCONCE
RAZZARI
HOME DEPOT SKU 602-035 | S/O: 435-865 (UPC 773546217538)
CHROME FINISH
PRODUCT MAINTENANCE:
1. To clean the outside of the lamp, use a dry or slightly dampened clean cloth (use
clean water, never a solvent) to wipe the shade and surface of the lamp.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning
off the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or
slightly dampened clean cloth (use clean water, never a solvent) to wipe the inside
shade and interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry
soft cloth to dust or wipe carefully.
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship
for a period of five (5) years from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the
manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident,
modifications, alterations, neglect or mishandling. This warranty shall not apply to any product that is
found to have been improperly installed, set-up, or used in any way not in accordance with the instructions
supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident,
misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material
or workmanship. This warranty shall not apply to the finish on any portion of the product, such as surface
and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and
specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other
than the warranty contained herein. The manufacturer specifically disclaims any liability and shall
not be liable for any consequential or incidental loss or damage, including but not limited to any labor
/ expense costs involved in the replacement or repair of said product.
Page 8
Page 1
Thank you for purchasing this Hampton Bay interior decorative lighting. This product
has been manufactured with the highest standards of safety and quality.
INSTALLATION:
3. Universal Crossbar
FEATURES:
4. Ground Screw
Ground Wire
Refined capiz shell strands radiate a simple elegance to this fixture that complements
any décor.
5. Outlet Box Screw (x2)
Black Wire
1. Junction Box
(not included)
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer Service
Team at 1-877-527-0313 or visit www.homedepot.com. Please reference your
SKU 602-035 or (UPC 773546217538).
CAUTION:
1. Before starting installation of this fixture or removal of a previous fixture, disconnect
the power by turning off the circuit breaker or by removing the fuse at the fuse box.
2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL
QUESTIONS.
If you have any non-electrical question about this fixture, please contact our Customer
Service Team at 1-877-527-0313 or visit www.homedepot.com. Please reference
your SKU 602-035 or (UPC 773546217538).
4. Keep your receipt and these Instructions for Proof of Purchase.
7. Canopy
2. Wire Nut (x3)
White Wire
8. Decorative Cap (x2)
6. Mounting Screw
Figure #1
Page 2
WHITE OR RIBBED
WHITE OR RIBBED
FROM HOUSE
FROM FIXTURE
BLACK (OR RED) WIRE
BLACK OR SMOOTH
FROM HOUSE
FROM FIXTURE
GROUND WIRE
GROUND WIRE
FROM HOUSE
FROM FIXTURE
Page 7
ADDITIONAL PARTS FOR INSTALLATION (included):
2. Wire Nut (x3)
6. Mounting Screw
(x2)
3. Universal
Cross Bar
4. Ground Screw
5. Outlet Box
Screw (x2)
8. Decorative Cap
(x2)
INSTALLATION INSTRUCTIONS:
1. Turn off power at main fuse box.
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
(not included):
Safety Goggles
Chain Pliers
Wire Strippers
Wire Cutters
Flathead
Screwdriver
Phillips
Screwdriver
Electrical Tape
B10 40W Bulb
(not included)
ADDITIONAL PARTS FOR ASSEMBLY (included):
2. Install universal crossbar (3) to junction box with 2 outlet box screws (5)
supplied. Make sure black and white wires of junction box (1) run through the
middle opening of the universal crossbar (3).
3. Fasten open end of ground wire (bare copper and green wire) to ground wire of
junction box (1). (See Figure 1).
Strand A
Strand B
4. Connect black wire of power supply to black wire of sconce and white wire of
power supply to white wire of sconce. (See Figure 1).
NOTE: All wire connections should be made with wire nuts (2) or marrettes (included)
and pushed back onto junction box (1). (See Figure 1).
5. Mount canopy (7) of sconce over the 2 mounting screws (6) of the universal
crossbar (3). Secure with 2 decorative caps (8).
Page 6
Page 3
ASSEMBLY INSTRUCTIONS:
1. Carefully unpack the fixture; lay out all parts on a clean surface.
2.
Install 40W max type B10 bulb (not included).
3.
Carefully unwrap one package of capiz shell at a time.
4.
Install alternatively the capiz shell strand (A) consisting of 8 pieces each onto the
inner frame (9).
5.
ASSEMBLY:
8. Decorative Cap
9. Inner Frame
B10 Bulb 40W Max
(not included)
Install alternatively the capiz shell strand (B) consisting of 5 pieces each onto the
outer frame (10).
10. Outer Frame
Socket
7. Canopy
Strand B
Strand A
Page 4
Page 5