Hampton Bay 14813-023 Installation Guide

TROUBLESHOOTING:
Bulb will not light
Fuse blows or circuit
breaker trips when light
is turned on
Possible Cause
Corrective Action
1. Bulb is burned out
1. Replace light bulb
2. Switch is off
2. Make sure switch is on
3. Faulty wire connection
3. Check wiring
Crossed wires or power
wire is grounding out
Check wire connections
INSTRUCTION MANUAL
INTERIOR 3-LIGHT BATHBAR
ALLURE
HOME DEPOT SKU# 444-607 S/O 454-703 (UPC# 773546170420)
ANTIQUE SILVER FINISH
PRODUCT MAINTENANCE:
1. To clean the outside of the lamp, use a dry or slightly dampened clean cloth (use
clean water, never a solvent) to wipe the shade and surface of the lamp.
off the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or
slightly dampened clean cloth (use clean water, never a solvent) to wipe the inside
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry
soft cloth to dust or wipe carefully.
LIMITED WARRANTY
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the
manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident,
found to have been improperly installed, set-up, or used in any way not in accordance with the instructions
supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident,
misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material
and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and
not be liable for any consequential or incidental loss or damage, including but not limited to any labor
expense costs involved in the replacement or repair of said product.
Page 8
Page 1
Thank you for purchasing this Hampton Bay interior decorative lighting. This product
has been manufactured with the highest standards of safety and quality.
INSTALLATION:
4. Ground Screw
3. Universal Cross Bar
FEATURES:
Extravagant and sophisticated, this bathbar vanity hearkens back to glorious Hellenistic
5. Wire Nut (x3)
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to you local Home Depot, please call our Customer Service Team at
1-877-527-0313 or visit www.homedepot.com. Please reference you SKU # (444-607)
or UPC # (773546170420).
White Wire
Ground Wire
Black Wire
CAUTION:
the power by turning off the circuit breaker or by removing the fuse at the fuse box.
2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL
QUESTIONS.
1. Mounting Screw (x2)
12. Junction Box
(not included)
2. Outlet Box Screw (x2)
Customer Service Team at 1-877-527-0313 or visit www.homedepot.com. Please
reference your SKU# (444-607) or UPC# (773546170420).
4. Keep your receipt and these Instructions for Proof of Purchase.
Page 2
Figure #1
WHITE OR RIBBED
WHITE OR RIBBED
FROM HOUSE
FROM FIXTURE
BLACK (OR RED) WIRE
BLACK OR SMOOTH
FROM HOUSE
FROM FIXTURE
GROUND WIRE
GROUND WIRE
FROM HOUSE
FROM FIXTURE
Page 7
ADDITIONAL PARTS FOR INSTALLATION (included):
1. Mounting Screw 2. Outlet Box
(x2)
Screw (x2)
3. Universal Cross 4. Ground Screw
Bar
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
(not included):
Safety Goggles
Wire Strippers
Wire Cutters
Flathead
Screwdriver
5. Wire Nut (x3)
Phillips
Screwdriver
INSTALLATION INSTRUCTIONS:
1. Turn off power at main fuse box.
2. Install universal cross bar (3) to junction box (12) with 2 outlet box screw
(2) supplied. Make sure black and white wires of junction box (12) run
through the middle opening of the universal cross bar (3).
Electrical Tape
A19 Bulb 60W max.
(not included)
ADDITIONAL PARTS FOR ASSEMBLY (included):
6. Decorative Cap
7. Glass Shade (x3)
10. Decorative
Crystal Drop
11. Decorative
Crystal
8. Spacer
9. Socket Ring
3. Fasten open end of ground wire (bare copper or green wire) to ground
wire of junction box (12).
4. Connect black wire of power supply to black wire of sconce.
NOTE: All wire connections should be made with wire nuts (5) or marrettes
(included) and pushed back into junction box (12).
5. Mount canopy (13) of sconce over the mounting screw (1) of universal
cross bar (3). Secure with 2 decorative caps (6).
Page 6
Page 3
ASSEMBLY INSTRUCTIONS:
ASSEMBLY:
2. Slip glass shade (7) over socket, secure glass shade (7) by placing spacer (8)
then tighten with socket ring (9). Do not over tighten!
3. Attach decorative crystals (11) across the front of the sconce canopy (4).
4. Attach decorative crystal drops (10) under each socket.
10. Decorative
Crystal Drop
5. Install 60W max. A19 bulb (not included).
11. Decorative Crystals
9. Socket Ring
8. Spacer
7. Glass Shade (x3)
4. Ground Screw
3. Universal Cross Bar
5. Wire Nut (x3)
White Wire
Socket
Ground Wire
Black Wire
6. Decorative
Cap
1. Mounting Screw (x2)
12. Junction Box
(not included) 2. Outlet Box Screw (x2)
Page 4
13. Canopy
Page 5