Sea Gull Lighting 44190-07 Installation Guide

HC-894
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
FOR YOUR SAFETY
051409
CLEANING
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE
WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR
THE CIRCUIT BREAKER OFF .
WARNING: USE OF OTHER MANUFACTURER’S COMPONENTS
WIlL VOID WARRANTY, LISTING, AND MAY CAUSE A POTENTIAL
SAFETY HAZARD
GENERAL
You don’t need special tools to install this fixture. Be sure to follow the
steps in the order given. Read instructions carefully. If you are
unclear as to how to proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this
fixture.
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
BEFORE YOU BEGIN
STEP 1:
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figures 1 & 2. Be careful not to misplace
any of the screws or parts which are needed to install this fixture.
*OUTLET BOX *#8-32
MOUNTING UNIVERSAL
OUTLET SCREWS (F) MOUNTING
BOX
PLATE (A)
SCREWS
BACKPLATE (G)
GLASS (B)
*SUPPLY
GROUND
WIRE
*ORANGE
WIRE
CONNECTORS
FIGURE 1
GREEN
GROUNDING
SCREW (E)
CAP NUTS (D)
RETAINING
RING (C)
*NOT SUPPLIED
INSTALLATION
HC-894
IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET
BOX.
STEP 1:
Insert fixture mounting screws (F) in threaded holes of universal
mounting plate (A). Run screws all the way down to the heads.
STEP 2:
Place universal mounting plate (A) against outlet box (not supplied)
and secure in place using outlet box screws (not supplied). Be sure
the mounting screws (F) are perfectly horizontal so fixture hangs
straight.
FINAL ASSEMBLY
Make sure no bare wires can be seen outside wire connectors.
STEP 1:
After wires are connected, tuck them carefully inside the outlet box.
Position backplate (G) over mounting screws (F) and secure in place
with cap nuts (D).
STEP 2:
Raise glass (B) and secure in place with retaining ring (C).
STEP 3:
Install lamps.
STEP 3:
A. Use an orange listed wire connector to connect the 18AWG
fixture hot wire (black wire, or round and smooth tracer) to the
supply hot wire.
B. Use an orange listed wire connector to connect the 18AWG
fixture common wire (white wire, or square and rigid) to the supply
common wire.
C. Gently try to remove the wires from the connector. If you can
remove the wires, carefully re-do the wiring connection.
STEP 4:
GROUNDING INSTRUCTIONS: The green grounding screw (E) is
to be inserted into the hole with two raised dimples provided on the
universal mounting plate (A). Wrap the ground wire from the outlet box
(bare metal or green insulated wire) around the green grounding
screw (E) on the universal mounting plate (A) and tighten the green
grounding screw to secure.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE
POWER SUPPLY WIRES.