Kenroy Home 32462AB Instructions / Assembly

 MODEL: 32462
PACKING DIAGRAM
GLASS SHADE
LAMP BODY -
| FOAM: 12 KGS.
re
= GLASS SHADE
32462GSAB
(REPLACEMENT
PART)
— SOCKET
ASE SCREW
(3 PCS)
LAMP
BODY
LN NN
| зитен
/
OWER
CORD
AVAILABLE PART:
32462GSAB (GLASS SHADE)
03/2014
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
READ INSTRUCTIONS ALL THE WAY THROUGH PRIOR TO
ASSEMBLY.
THIS LAMP SHOULD TAKE APPROXIMATELY 2 MINUTES TO
ASSEMBLE.
MAKE SURE ALL PARTS ARE FIRMLY TIGHTENED.
UNPACK THE LAMP
YOU SHOULD HAVE RECEIVED THE FOLLOWING PARTS IN THE
PACKAGE: GLASS SHADE, (3) SCREWS AND LAMP BODY. TO
PROTECT THE FINISH, PLACE ALL PARTS ON A SOFT
SURFACE.
ASSEMBLE THE LAMP
1. CAREFULLY ORGANIZE AND PLACE ALL PARTS ON A
SMOOTH, FLAT SURFACE. LINE UP ALL OF THE PARTS
ACCORDING TO THE ASSEMBLY DIAGRAM.
2. INSTALL A 100 WATT MAXIMUM MEDIUM BASE TYPE "A"
BULB (NOT INCLUDED) INTO THE SOCKET.
5. PLACE THE GLASS SHADE ONTO THE BASE, THEN SECURE
WITH (3) SCREWS. (NOTE: TO PREVENT BREAKING THE GLASS
SHADE, DO NOT OVER TIGHTEN THE SCREWS)
4. PLUG THE POWER CORD INTO AN OUTLET AND TURN ON
AT SWITCH.
BULB REPLACEMENT
1. BEFORE REPLACING THE BULB, BE SURE THAT THE GLASS
SHADE AND BULB ARE COOL AND LAMP IS UNPLUGGED.
2. REMOVE THE GLASS SHADE BY UNSCREWING (3) SCREWS,
UNSCREW THE EXISTING BULB FROM SOCKET AND REPLACE
WITH A NEW BULB. REPLACE THE GLASS SHADE AND SECURE
WITH (3) SCREWS. PLUG POWER SUPPLY CORD BACK INTO
OUTLET.
TROUBLE SHOOTING
1. IF YOUR LAMP DOES NOT LIGHT, CHECK PLUG AT THE
OUTLET. MAKE SURE THE PLUG IS FULLY AND PROPERLY
INSERTED INTO THE POWER OUTLET.
2. IF LAMP STILL DOES NOT LIGHT, UNPLUG FROM OUTLET.
CHECK THE BULB FOR A BROKEN FILAMENT. REPLACE BULB
IF NECESSARY, PLUG IN LAMP AND TURN IT ON.
3. IF THE LAMP STILL DOES NOT LIGHT, PLEASE CONTACT
YOUR DISTRIBUTOR OR PLACE OF PURCHASE.
IMPORTANT SAFETY INSTRUCTIONS
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE
IS WIDER THAN THE OTHER) AS A FEATURE TO REDUCE THE
RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A
POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG DOES NOT
FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL
DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN. NEVER
USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY
INSERTED. DO NOT ALTER THE PLUG.
32462AB INSTRUCTIONS