the great outdoors by Minka Lavery 72416-51A-L Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72416-51A-L
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the circuit breaker and remove the old fixture
including the mounting hardware.
B
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. While supporting the fixture, connect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are secured. If your post
has a ground wire (green or bare copper), connect the fixture ground
wire to it. If not, consult your electrician for proper grounding. After
wires are connected, tuck them carefully inside the post cup (X).
4. Align the fixture to post (X) and secure with screws (H).
5. Bulb (G) information: (1 x AC LED 10W included.)
DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE
PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
COMPLETING THE INSTALLATION (Fig. 1)
Fig. 2
6. Remove top cover (A) by loosening screws (B).
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
7. Place the small round glass (F) over LED module (O).
HOUS
E
WIRES
Black
(Hot)
8. Re-attach top cover (A) with screws (B).
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any decorative
element to which the fixture is attached. See installation steps for
more details (Fig 3.)
1.
Fig.3
I (Module ring)
Q(LED module)
Remove top cover (A) by loosening screws (B).
a. Remove the small round glass (F) followed by clear seedy
glass (E) and cage (D) by loosening screws (K).
b. Remove wire nuts (L) and loosen module screws (H).
c. Carefully remove the LED module (Q) for re-lamping. Note:
The LED module should be provided by a specified supplier.
d. For better heat dissipation the LED module (Q) should be
installed with the heat transfer material (P) when re-lamping
Your installation is now complete. Return power to the
junction box and test the fixture
P(Graphite sheet)
K
L
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUS
E
WIRES
White
(Neutra
l)
HOUS
E
WIRES
Green
or
Bare
Copper
(Groun
d)