the great outdoors by Minka Lavery 8206-94 Instructions / Assembly

INSTALLATION INSTRUCTIONS
Model # 8206
READ AND SAVE THESE INSTRUCTIONS
W ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
1. Shut off power at the circuit breaker and remove old
fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts i n a clear area. Take care not to misplace any
small parts necessary for installation.
3. Unscrew the cap nut (F) then move the top cover (J),
insert the nipple(C) with the rubber (B) and the f inial (A)
into the top cover (J), have the key washer (D) through
the nipple (C) with the hex nut (E) tightly inside the top
cover (J) (Fig.1).
4. Pull black, white and ground wires out of post (I).
5. Connect electrical wires while supporting the lantern. If
your post has a ground wire (green or bare copper),
connect the fixture ground wire to it. If not, consult your
electrician for proper grounding. After wires are
connected, tuck them carefully inside the post cup (G).
Align the lantern with post (I) and secure with sheet
metal screws (H). (Fig.1&2)
6. At this point, install the light bulb in accordance with the
fixture specification —DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
7. Replace the top cover (J) and secure with cap nut (F).
Fig. 1
J
F
I
Your installation is now complete. Return power to and test
the fixture.
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
R
Fig.2
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
FIXTURE
WIRES
WHITE
FIXTURE
WIRES
BLACK
HOUSE
WIRES
BLACK
(HOT)
HOUSE
WIRES
WHITE
(NEUTRAL)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)