the great outdoors by Minka Lavery 9806-144 Instructions / Assembly

INSTALLATION INSTRUCTIONS FOR 9806- PL
For Post Lamp Fixture
READ AND SAVE THESE INSTRUCTIONS
WARNING!
SHUT POWER
OFF AT FUSE OR
HANG THE FIXTURE (Fig.1)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Place the fixture on the top of the POST on which is to be mounted
and position as desired. Using the holes located on the POST
CAP mark the holes position on the POST. Remove the fixture
from the POST and drill a 1/8” diameter hole at each marked
position on the POST.
Pull the power supply wires out from the POST and the fixture lead
wires out from the POST CAP. Connect the electrical wires as
shown in Fig.2 make sure all wire nuts are secured .You may have
to wrap connections with electrical tape. Attach the POWER
SUPPLY GROUND WIRE to the FIXTURE GROUND WIRE.
Using a wire connector rated for the size of wires being connected.
Place the connected wires down inside the POST and mount the
POST CAP in place. Aligning the holes in the POST CAP with the
POST, secure the POST CAP to the POST using 3 x 1/2” long self
Tapping SHEET METAL SCREWS provided.
Install the PL lamp in according with the fixture’s specification.
(1×Max 26W included). (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!!)
The ballast in each of these models can be replaced by a qualified
electrician without cutting of wires and without damage to the
housing, trim, decorative elements or carpentry to which the fixture
is attached. See installation steps for more detail. The ballast and
lamp are combined, to replace or install, twist pins into socket as
shown on Fig.3
Place the glass with narrow side towards the lamp cover into the
fixture. Place the LAMP COVER onto the top of the lamp
compartment.
If there’re any loose parts on the body because of the
transportation, please fix the hex screws with the wrench provided.
This fixture contains an integrated photo sensor that automatically
prevents operating during daylight hours.
This fixture is rated for a minimum start temperature of -17°
Celsius.
This fixture is UL Listed for Wet Location applications.
Your installation is now complete. Return power to the junction box and
test the fixture.
LIMITED 2 YEAR WARRANTY
This Fixture is covered by a Limited 2 year Warranty from the
Manufacturer, effective from the date of purchase. This fixture is
warranted against defects in the quality of the housing, trims,
diffuser, shades, and electrical components. Fixture finishes and/or
lamps (bulbs) are expressly excluded from this warranty; refer to
bulb manufacturer for lamp warranty. This Fixture, if supplied with
an automatic shut off sensor, motion control sensor, or photocell,
cannot be installed in conjunction with any other device without
voiding warranty. Modifying this fixture or use of another
non-provided control will also void Product Warranty and UL listing.
II366
CIRCUIT BREAKER .