the great outdoors by Minka Lavery 72397-143C Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72397
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
Fig. 1
1. Shut off the power at the circuit breaker and remove the old
fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on
a clear area. Take care not to lose any small parts necessary
for installation.
3. Attach the mounting plate (C) to the outlet box (A) (not
supplied) with mounting screws (B) (Size: #8-32*0.78’’L)
4. Thread the mounting screws (E) into the threaded holes in
mounting plate (C) spaced the same distance apart as the
mounting holes in the fixture backplate (D). Note: The length
of the mounting screws into the mounting plate (C) may be
adjusted if necessary.
Set A#: A020-1
-Mounting plate
-Ground screw
-Mounting screws(2)
S
R
T
CONNECTING THE WIRES (Fig. 2)
A
5. Connect the electrical wires as shown in Fig.2 making sure
that all wire connectors are secured. If your outlet box has a
ground wire (green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s ground wire
directly to the circular strap using the green screw provided.
COMPLETING THE INSTALLATION (Fig. 1)
6. Place the fixture over the mounting screws (E), and secure
with lock nuts (F).
7. To prevent moisture from entering the outlet box and causing
a short, use clear caulking (i.e. Indoor/Outdoor Silicone
Sealant) to outline the outside of fixture backplate where it
meets the wall leaving a space at bottom to allow moisture a
means to escape. (Fig. 3)
8. Bulb G information: (1 x AC LED 10W included.)
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
(NE PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
()
E CB D F
G
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Bare
Copper(G
round)
Fig. 3
Replacing LED module (Fig. 4)
The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any decorative
element to which the fixture is attached. See installation steps for
more details (Fig 4.)
a. Turn off power circuit breaker. Separate fixture body (T) from
top cover (S) by removing screws (R) (Fig.1).
b. Remove aluminum plate (O) by loosening screws (K).
c. Remove wire nuts (L) hex-nuts (N) washers (M) and
carefully remove LED module (Q) for re-lamping. Note: The
LED module should be provided by a specified supplier.
d. For better heat dissipation the LED module (Q) should be
installed with the heat transfer material (P) when re-lamping
.
Your installation is now complete. Return power to the
junction box and test the fixture
Caulking
Backplate
N
Fig. 4
M
L
O
P (Graphite sheet)
K
J (Glass)
I (Module ring)
H (Module screws)
Q (LED module)