the great outdoors by Minka Lavery 8997-66 Installation Guide

INSTALLATION INSTRUCTIONS
Model # 8997
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
Fig. 1
1. Shut off power at the circuit breaker (avertissement!
couper le courant au niveau des fusibles ou du
disjoncteur) and remove the old fixture including
mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Thread the two studs (B) into the pre-drilled holes in
the circular strap (C) spaced the same distance
apart as the holes in the back plate (H), then tighten
with the nut (E). Note: The length of studs (B) into
circular strap (C) may be adjusted if necessary.
4. Attach circular strap (C) (Part#A-020) using
mounting screws (F) (Part#8/32”*1”L) to the outlet
box (A), (Fig 1).
CONNECTION THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in
Fig.2.Making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
or bare copper), connect the fixture’s ground wire to
it. Otherwise, connect the fixture’s ground wire
directly to the circular strap using the green screw
(D) (Part#8/32”*1/3”L) provided.
Fig.2
HOUSE
WI RES
BLACK
( HOT)
FINISHING THE INSTALLATION (Fig.1)
6. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone sealant to
outline the outside of fixture back plate (H) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape.
7. Align back plate (H) onto stud (B) and secure with
cap nut (G). (Fig 1)
8. At this point, unscrew the screws (I), remove the
cage (J) with the shade to install 1*100W A bulb in
accordance with the fixture specification—DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!
(NOTE: NO BULB INCLUSED) (NE PAS
DEPASSER
LA
PUISSANCE
NOMINALE
MAXIMALE!)
9. Replace the cage (J) with the shade, secure with the
screws (I).
Your installation is now complete. Return power to the
outlet box and test the fixture.
FI XTURE
WI RES
GREEN OR
BARE
COPPER
( GROUND)
FI XTURE
WI RES
WHI TE
FI XTURE
WI RES
BLACK
HOUSE
WI RES
WHI TE
( NEUTRAL)
HOUSE
WI RES
GREEN OR
BARE COPPER( GROUND)
Fig 3
Caulking
Backplate