the great outdoors by Minka Lavery 8693-61 Installation Guide

INSTALLATION INSTRUCTIONS
Model # 8692/8693
READ AND SAVE THESE INSTRUCTIONS
WARNING!
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
1. Shut off power at the circuit breaker and remove old
fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. You need to make two holes on the wall in correct
position in accordance with the long strap (C) and the
outlet box (A), then insert the anchor (E) into the hole.
4. Pull black and white wires out of electrical outlet box
(A).
5. Thread the four studs (B) into the pre-drilled holes in the
long strap (C) spaced the same distance apart as the
holes in the back plate (F).
6. Attach long Strap (C) using Outlet Box Screws (D) to
the outlet box (A), screw the wood screws (G) into the
anchor (E) (Fig 1).
7. Connect the electrical wires as shown in Fig.2. Making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s Ground wire to it. Otherwise, connect the
fixture’s Ground wire directly to the long strap using the
Green Screw (H) provided.
8. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone Sealant to
outline the outside of fixture back plate (F) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape.
9. Place the back plate (F) into stud (B) and secure it
tightly against the wall using cap nut (I). (Fig 1)
10. At this point, unscrew the finial (K) and the nut (L),
remove the cage (J) gently to install the light bulbs in
accordance with the fixture specification--DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!
11. Replace the cage (J), secure with the nut (L) and the
finial (K).
Fig. 1
Fig.2
FI XTURE
WI RES
GREEN OR
BARE
COPPER
( GROUND)
FI XTURE
WI RES
WHI TE
FI XTURE
WI RES
BLACK
HOUSE
WI RES
BLACK
( HOT)
HOUSE
WI RES
WHI TE
( NEUTRAL)
HOUSE
WI RES
GREEN OR
BARE COPPER( GROUND)
Your installation is now complete. Return power to the
outlet box and test the fixture.
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
U.S. Patents: D457,681; D461,591;
D463,062
This product is protected by United
States Federal and/or State Law,
including Patent and/or Copyright laws.