the great outdoors by Minka Lavery 9803-143 Installation Guide

INSTALLATION INSTRUCTIONS FOR 9803
For Wall Sconce Fixture
WARNING!
SHUT POWER OFF
AT
FUSE
OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box
(avertissement! couper le courant au niveau des
fusibles ou du disjoncteur) and remove the old fixture,
including the mounting hardware.
1. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
2. Attach the crossbar(Part#A-010) to the junction box
with mounting screws (Size:8-32*1/2”L). The side of
the crossbar marked “GND” must face out.
3. Thread the nipple part way into the center hole of the
crossbar. The length of the nipple into the crossbar may
be adjusted if necessary.
Crossbar
Mounting Screws(2)
Green Screw
CONNECTING THE WIRES (Fig.2)
4. At this point, connect the electrical wire as shown in Fig.
2, making sure that all wire connectors are secured. If
your outlet has a ground wire (green or bare copper),
connect the fixtures ground wire to it. Otherwise,
connect the fixture ground wire directly to the crossbar
using the green screw provided. After wires are
connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig.1)
5. Align the fixture back plate to the nipple and secure
with the cap nut provided
6. Notice: To comply with UL Standards and maintain
product warranty, use clear silicone sealant to outline
the outside of the fixture back plate where it meets the
wall to prevent moisture from entering the junction box
while leaving a space at the bottom to allow moisture to
escape (Fig 3.). Failure to do so will void any expressed
warranty.
7. Install the light bulbs (2×A19 60W not included) in
accordance with the fixture’s specification: DO NOT
EXCEED
THE
MAXIMUM
WATTAGE
RATING!
(NE
PAS
DEPASSER
LA
PUISSANCE NOMINALE MAXIMALE!)
8. Place the glass with the marked arrow on the topside
into the fixture and secure the steel glass support bar with
the screws and plastic washer provided.
Your installation is now complete. Return power to
the junction box and test the fixture.
MIN 75℃ SUPPLY CONDUCTORS
II 041
Fig.3