the great outdoors by Minka Lavery 8202-61 Instructions / Assembly

INSTALLATION INSTRUCTIONS
Model # 8201 /8202
READ AND SAVE THESE INSTRUCTIONS
W ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
1. Shut off power at the circuit breaker and remove old
fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Pull black and white wires out of electrical outlet box
(A).
4. Thread the two studs (B) into the pre- drilled holes in
the cross bar (C) spaced the same distance apart as
the holes in the back plate (H), then tighten with the
nut (E).
5. Attach cross bar (C) using Outlet Box Screws (F ) to
the outlet box (A), (Fig 1).
6. Connect the electrical wires as shown in Fig.2.
Making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture ’s Ground wire to it.
Otherwise, connect the fixture’s Ground wire directly
to the cross bar (C)
using the Green Screw (D)
provided.
7. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone Sealant to
outline the outside of fixture back plate (H) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape.
8. Place the back plate (H) into stud (B) and secure it
tightly against the wall using cap nut (G). (Fig 1)
9. At this point, unscrew the cap nut (I), move the cage
(J) to install the light bulbs in accordance with the
fixture specification —DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
10. Insert the finial (N) into the bottom of cage (J), place
the key washer (L) through the nipple (M) and
secure with the hex nut (K), then replace the cage
(J), secure with the cap nut (I).
Your installation is now complete. Return power to the
outlet box and test the fixture.
Fig. 1
L
M
N
Fig.2
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
FIXTURE
WIRES
WHITE
FIXTURE
WIRES
BLACK
HOUSE
WIRES
BLACK
(HOT)
HOUSE
WIRES
WHITE
(NEUTRAL)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
R