the great outdoors by Minka Lavery 72211-615B Instructions / Assembly

INSTALLATION INSTRUCTION
Item#72211 (New. 12/18/2012)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box.
Remove the old fixture and mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Attach the circular strap (A) to the junction box with
the two junction box screws (B) as shown. The side
of the circular strap marked “GND” must face out.
4. Thread the studs (C) into the pre-drilled holes in the
circular strap (A) spaced the same distance apart as
the holes in the back-plate.
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in (Fig.2),
making sure that all wire connectors are secured. If
your outlet has a ground wire (green or bare
copper), connect the fixture ground wire to it.
Otherwise, connect the fixture ground wire directly to
the crossbar using the green screw provided.
COMPLETING THE INSTALLATION
6. Align backplate (D) onto Studs (C) and secure with
knurled knobs (E).
7. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e.
Indoor/Outdoor Silicone Sealant) to outline the
outside of fixture back-plate where it meets the wall
leaving a space at bottom to allow moisture a means
to escape (Fig.3).
8. Install 1*60W A19 bulb (not included) in accordance
with the fixture’s specification. (DO NOT EXCEED
THE SPECIFIED WATTAGE!) (NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!)
Fig. 1
A
B
C
D
E
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)
Fig. 3
CAULKING
Your installation is now complete. Return the power to
the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-1955E
BACKPLATE