the great outdoors by Minka Lavery 9156-A357 Instructions / Assembly

INSTALLATION INSTRUCTION
For item#9156-A357 (New. 05/10/2012)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION (Fig. 1)
1. Shut off power at the circuit breaker box and
remove the old fixture including mounting
hardware.
2. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose
any small parts necessary for installation.
Fig. 1
E
D
C
CONNECTING THE WIRES (Fig. 2)
3. Pull the black, white and ground wires out of Post.
4. Next, connect electrical wires while supporting the
lantern. If your outlet has a ground wire (green or
bare copper), connect the fixture ground wire to it.
If not, consult your electrician for proper
grounding. After wires are connected, tuck them
carefully inside the post. Align the lantern with
post and secure with Screws (A) (Fig 1 & 2 ).
COMPLETING THE INSTALLATION
5. At this point, you may install 2*60W B10.5 light
bulbs (not included) in accordance with the
fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
6. For installing or replacing bulbs at a later date.
Loosen Finial (E) and remove Nut (D), Roof (C).
After installation, place Roof(C). Nut (D) ever the
tube and secure them with Finial (E).
TUBE
B
A
Fig. 2
FIXTURE
WIRES
Black or
Smooth
Your installation is now complete. Return the
power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2038E
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)