the great outdoors by Minka Lavery 9060-91 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 9060
READ AND SAVE THESE INSTRUCTIONS
WA R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the 2 mounting screws (E) into the mounting
plate(C) spaced the same distance apart as the holes in
the fixture back plate. (You can adjust the length of the
screws if necessary.)
4. Attach the mounting plate (C) to the outlet box (A) (not
supplied) with mounting screws (B). (Size: #8-32*0.78"L).
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig.2.Making sure
that all wire connectors are secured. If your outlet box has
a ground wire (green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the circular strap using the green screw
provided.
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
COMPLETING THE INSTALLATION (Fig. 1)
6. Align the fixture (M) to the mounting plate (C) and secure
with cap nuts (F).
HOUSE
WIRES
Black
(Hot)
7. Attach the bottom finial (P) to stem (O) and top finial (G) to
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Bare
Copper(Gr
ound)
the top cover (K).
8. Fix the glass into the fixture body (M) with the clips,
gaskets and screws provided.
Fig. 3
9. Install the bulb (A-19medium base, not supplied) in
accordance with the fixture’s specifications. DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
10. Connect the top cover (K) to the fixture body (M) with
screws (N)
Caulking
11. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e. Indoor/Outdoor
Silicone Sealant) to outline the outside of fixture back plate
where it meets the wall leaving a space at bottom to allow
moisture a means to escape.
(Fig. 3)
Your installation is now complete.
junction box and test the fixture
Return power to the
Backplate