the great outdoors by Minka Lavery 72420-212 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72420-212 (Rev. 06/19/2013)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig.1)
1. Shut off the power at the circuit breaker and remove
the old fixture and mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Attach the crossbar (A) to the outlet box with mounting
screws (B) (Size: #8-32N*L0.5”). The side of the
crossbar marked “GND” must face out.
4. Thread the nipple (C) part way into the center hole of
the crossbar (A). Note: The length of nipple (C) into
crossbar (A) may be adjusted if necessary.
Fig. 1
Set# A-016
-Crossbar
-Ground Screw
-Mounting Screw*2
A
B
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to
the crossbar using the green screw provided. After the
wires are connected carefully tuck them inside the
outlet box.
C
G
D
E
COMPLETING THE INSTALLATION (Fig.1)
6. Pull up the latch (E) and open the door.
7. Align the fixture body (G) to nipple (C) and secure with
knurled knob (D).
8. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e.
Indoor/Outdoor Silicone Sealant) to outline the outside
of fixture back-plate where it meets the wall leaving a
space at bottom to allow moisture a means to escape
(Fig.3).
9. Install 2*60W B10.5 bulb(s) (not included) in
accordance with the fixture’s specifications. (DON’T
EXCEED THE MAXIMUM WATTAGE RATING!!) (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
10. When replacing the glass (F), pull up the latch (E)
and open the door. Loosen the clips and remove glass
(F). After replacing the glass, re-tighten the glass clips,
and then close the door.
11. For installing or replacing bulbs at a later date, pull
up the latch (E) and open the door. (Fig.1)
F
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
Fig. 3
CAULKING
Your installation is now complete. Return the power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
MIN 90℃ SUPPLY CONDUCTORS
LA-2324E
HOUSE
WIRES
Green
(Ground)
BACKPLATE