the great outdoors by Minka Lavery 8990-66 Installation Guide

INSTALLATION INSTRUCTIONS
Model # 8990
READ AND SAVE THESE INSTRUCTIONS
WARNING!
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
Fig. 1
1. Shut off power at the circuit breaker (avertissement!
couper le courant au niveau des fusibles ou du
disjoncteur) and remove the old fixture including
mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Attach crossbar (B) (Part#A-012) using junction box
screws (C) (Part#8/32”*1”L) to the outlet box (A). (Fig 1)
CONNECTION THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig.2.Making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the crossbar using the
green screw (D) (Part#8/32”*1/3”L) provided.
FINISHING THE INSTALLATION (Fig.1)
5. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone sealant to outline
the outside of fixture back plate (G) where it meets the
wall leaving a space at bottom to allow moisture a
means to escape. (Fig 3)
6. Align back plate (G) onto nipple (E) and secure with cap
nut (F)(Fig 1).
7. At this point, unscrew the screws (J&K), remove the top
cover (I) with the top back plate (H) to install 1*100W A
bulb in accordance with the fixture specification –DO
NOT EXCEED THE MAXIMUM WATTAGE RATING!
(NOTE: NO BULB INCLUDED) (NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!)
Fig.2
FI XTURE
WI RES
GREEN OR
BARE
COPPER
( GROUND)
FI XTURE
WI RES
WHI TE
FI XTURE
WI RES
BLACK
HOUSE
WI RES
BLACK
( HOT)
HOUSE
WI RES
WHI TE
( NEUTRAL)
HOUSE
WI RES
GREEN OR
BARE COPPER( GROUND)
Fig 3
8. Replace the top cover (I) with top back plate (H) and
secure with the screws (J&K).
Your installation is now complete. Return power to the
outlet box and test the fixture.
Caulking
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
Backplate
U.S. Patents No: D455,515; D455,856;
This product is protected by United States
Federal and/or State Law, including Patent
and/or Copyright laws.
© Minka Lighting Inc.