the great outdoors by Minka Lavery 72170-189 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72170-189
READ AND SAVE THESE INSTRUCTIONS
WARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
1.
2.
3.
4.
5.
Shut off power at the circuit breaker and remove the old fixture,
including the mounting hardware.
Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any parts necessary for installation.
Thread the two studs (L) into the pre-drilled holes in the mounting
plate (K) spaced the same distance apart as the holes in the back
plate. Note: The length of studs (S) into mounting plate (K) may be
adjusted if necessary.
Attach the mounting plate (K) to the outlet box (not provided) with
screws (M) (Size: 8-32*1/4”) as shown.
Align the curved end of scroll arm (C) through the decorative ring (D)
and secure the other end to the top cover with screw (A) (Size:
M4*10) hex nut (F), gasket (E) and washer (B).
Fig.1
Set A#:
-Mounting plate
-Ground screw
-Mounting screws(2)
CONNECTING ELECTRICAL (Fig.2)
6.
7.
Connect the electrical wires as shown in (Fig.2), making sure that all
wire connectors are secured. If your outlet has a ground wire (green
or bare copper), connect the fixture ground wire to it. Otherwise,
connect the fixture ground wire directly to the mounting plate using
the green screw provided.
To prevent moisture from entering the outlet box and causing a short,
use clear caulking (i.e. Indoor/Outdoor Silicone Sealant) to outline the
outside off fixture back-plate where it meets the wall leaving a space
at bottom to allow moisture a means to escape (Fig3).
COMPLETING THE INSTALLATION (Fig.1)
8.
Align the fixture and reflector (U) to mounting screws (L) (Size:
8-32*1/2) and secure with cap nuts and washers (V).
9. Place the candle sleeves (O) over the sockets (Q).
10. Install the 2*60W light bulbs (W) in accordance with the fixtures
specification.(DO NOT EXCEED THE MAXIMUM
WATTAGE
RATING!)(NE PAS DEPASSER
PUISSANCE NOMINALE MAXIMALE!)
LA
11. Align the glass (T) into body (S) and secure with glass clips (P).
Your installation is now complete. Return power to the junction box and
test the fixture.
“CAUTION-RISK
OF FIRE CONSULT
A QUALIFIED
ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR”
ATTENTION
–
RISQUE
D’INCENDIE,
CONSULTER
UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE LES
CONDUCTEURS DE LA DÉRIVATION SONT ADÉQUATS.
Fig.3