the great outdoors by Minka Lavery 8265-66-L Instructions / Assembly

INSTALLATION INSTRUCTIONS
Model #8265-L 8266-L
W AR N IN G !
READ AND SAVE THESE INSTRUCTIONS
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
、
、
1. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Pull the black, white and ground wires out of post (A).
4. While supporting the fixture, connect electrical wires. If
your post has a ground wire (green or bare copper),
connect the fixture ground wire to it. If not, consult your
electrician for proper grounding. After wires are
connected, tuck them carefully inside the post cup (B).
5. Align the lantern with post (A) and secure with screws
(C). (Fig.1&2)
6. Bulb (L) information (1 x AC LED 10W included.)
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
Replacing LED module (Fig.3)
The LED module can be replaced by a qualified
electrician without cutting of wire and without damage to
any decorative element to which the fixture is attached. See
installation steps for more details (Fig.3).
a. Shut off power, unscrew finial (D), remove washer (E)
and top covers (F&G). Remove aluminum panel (J) with
support (I) by loosening hex nuts (H) from the fixture
cage .
b. Unplug the male and female jacket (P&Q), loosening
screws (N) and carefully remove LED module (L) for relamping. Note: The LED module should be provided by
a specified supplier.
c. For better heat dissipation the LED module (L) should be
installed with the heat transfer material (K) when relamping.
Fig.1
C
B
A
F ig.2
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
FIXTURE
WIRES
WHITE
FIXTURE
WIRES
BLACK
HOUSE
WIRES
BLACK
(HOT)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)
HOUSE
WIRES
WHITE
(NEUTRAL)
Fig. 3
E
D
Your installation is now complete. Return power to the
outlet box and test the fixture.
F
G
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
P
H
I
Q
K
O
J
M L(LED Module)
N