the great outdoors by Minka Lavery 8992-61 Installation Guide

INSTALLATION INSTRUCTIONS
Model # 8991/8992/8993
READ AND SAVE THESE INSTRUCTIONS
W ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
1. Shut off power at the circuit breaker and remove
old fixture including mounting hardware.
2. Carefully unpack your new fixture and lay out all
the parts in a clear area. Take care not to misplace
any small parts necessary for installation.
3. You need to make two holes on the wall in correct
position in accordance with the long strap ( B) and
the outlet box (A), then insert the anchor (I) into
the hole.
4. Pull black and white wires out of electrical outlet
box (A).
5. Thread the nipple (C) into the pre-drilled holes in
the long strap (B) spaced the same distance apart
as the holes in the bottom back plate (K).
6. Attach long Strap (B) using Outlet Box Screws (D )
to the outlet box (A), Screw the wood screws (G)
into the anchor (I) (Fig 1).
7. Connect the electrical wires as
shown in Fig.2.
Making sure that all wire connectors are secured.
If your outlet box has a ground wire (green or bare
copper), connect the fixture ’s Ground wire to it.
Otherwise, connect the fixture
’s Gr ound wire
directly to the long strap using the Green Screw
(J) provided.
8. To prevent moisture from entering the outlet box
(A) and causing a short, use clear silicone Sealant
to outline the outside of fixture back plate (F)
where it meets the wall leaving a space at bottom
to allow moisture a means to escape.
9. Place the bottom back plate (K) into nipple (D) and
stud (H), then secure it tightly against the wall
using cap nut (E,F). (Fig 1)
10. At this point, unscrew the screws (M&O), remove
the top cover (N) with the top back plate (L) gently
to install the light bulbs in accordance with the
fixture specification —DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
11. Replace the top cover (N) with top back plate (L),
secure with the screws (M&O).
Your installation is now complete. Return power to the
outlet box and test the fixture.
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
Fig. 1
o
F
G
I
Fig.2
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
FIXTURE
WIRES
WHITE
FIXTURE
WIRES
BLACK
HOUSE
WIRES
BLACK
(HOT)
R
HOUSE
WIRES
WHITE
(NEUTRAL)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)