the great outdoors by Minka Lavery 9273-277 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 9273-277
READ AND SAVE THESE INSTRUCTIONS
WARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
MOUNTING THE FIXTURE (Fig.1)
1. Shut off power at the circuit breaker and remove the
old fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any parts
necessary for installation.
3. Attach the mounting plate to the outlet box with the
two outlet box screws as shown. The side of the
mounting plate marked “GND” must face out.
Fig.1
COMPLETING THE INSTALLATION
4. Install the glass to lamp frame with glass retainer
clips.
5. Install the bottom circle with the Phillips screws.
6. Install 3*60w B10.5 bulbs in accordance with the
fixture’s specification. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!)
CONNECTING ELECTRICAL (Fig.2)
7. Connect the electrical wires as shown in (Fig.2),
making sure that all wire connectors are secured. If
your outlet has a ground wire (green or bare
copper), connect the fixture ground wire to it.
Otherwise, connect the fixture ground wire directly
to the mounting plate using the green screw
provided.
8. Align the fixture to the mounting screws on the
mounting plate and secure with knurled knobs
(Fig1).
9. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e.
Indoor/Outdoor Silicone Sealant) to outline the
outside off fixture back-plate where it meets the wall
leaving a space at bottom to allow moisture a
means to escape (Fig3).
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased
Fig.3