the great outdoors by Minka Lavery 72413-51A-L Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72411-51A-L /72412-51A-L /72413-51A-L
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the old
fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts necessary for
installation.
3. Thread the 2 mounting screws (E) into the mounting plate (C)
spaced the same distance apart as the holes in the fixture
back plate. (You can adjust the length of the screws if
necessary.)
4. Attach the mounting plate (C) to the outlet box (A) (not
supplied) with mounting screws (B). (Size: #8-32*0.78"L).
Fig. 1
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig.2.Making sure
that all wire connectors are secured. If your outlet box has a
ground wire (green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s ground wire
directly to the circular strap using the green screw provided.
COMPLETING THE INSTALLATION (Fig.1)
6. Align the fixture back plate to mounting screws (C) and secure
with cap nuts (E).
7. To prevent moisture from entering the outlet box and causing
a short, use clear caulking (i.e. Indoor/Outdoor silicone
sealant) to outline the outside of fixture back plate where it
meets the wall leaving a space at bottom to allow moisture a
means to escape. (Fig. 3)
8. Bulb (H) information: (1 x AC LED 10W included.)
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
(NE PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Bare
Copper(G
round)
Fig. 3
Replacing LED module (Fig. 4)
The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any decorative
element to which the fixture is attached. See installation steps for
more details (Fig 4.)
a. Remove top cover (F) by loosening screws (G) (Fig.1), then
remove aluminum cover (O) by loosening screws (K).
b. Remove the wire nuts (L) hex-nuts (N) washers (M) and
carefully remove the LED module (Q) for re-lamping. Note:
The LED module should be provided by a specified supplier.
c. For better heat dissipation the LED module (Q) should be
installed with the heat transfer material (P) when re-lamping
.
Your installation is now complete. Return power to the
junction box and test the fixture
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
Caulking
Backplate
Fig. 4
O
K
P(Graphite sheet)
Q(LED module)
T (Module ring)