the great outdoors by Minka Lavery 8815-57 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Outdoor Lantern (New.07/16/2012)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AV E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D U D I S J O N C T E U R .
HANGING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove
the old fixture from the ceiling, including the old
crossbar.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for the installation.
3. Pull black and white wire out of electrical outlet box.
4. Mount circular strap to outlet box. The side of the
crossbar (A) marked “GND” must face out. (Fig.1)
CONNECTING THE WIRES (Fig. 2,3)
5. Connect electrical wires as shown making sure all
wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect the
fixtures Ground Wire to it. If not, connect the fixture
Ground Wire directly to the Crossbar using the
Green Screw provided. After wires are connected,
tuck them carefully inside junction box. (Fig.2)
6. To prevent moisture from entering the outlet box and
causing
a
short,
use clear
caulking(i.e.
Indoor/Outdoor Silicone Sealant) to outline the
outside of fixture backplate where it meets the wall
leaving a space at bottom to allow moisture a means
to escape. (Fig.3)
COMPLETING THE INSTALLATION (Fig. 1)
7. Align fixture to stud screws on circular strap and attach
fixture with Knurled knobs. (Fig.1)
8. Install the bulb (not included) in accordance with the
fixture’s specification. (DO NOT EXCEED THE
MAXIMUM
WATTAGE
RATING!)
(NE
PAS
DEPASSER
LA
PUISSANCE
NOMINALE
MAXIMALE!)
9. For installing or replacing bulb at a later date, install or
replace it to the socket from the bottom of the fixture.
(Fig. 1)
Fig.1
Dome
Assembly
Finial
Knurled
Knobs
Mounting
Screws
Circular Strap
Stud Screws
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
Fig. 3
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)
BACKPLATE
Your installation is now complete. Return power to the
junction box and test the fixture.
CAULKING
Note: Illustration (Fig. 1) on this manual is for installation
purposes only. It may or may not be identical to the fixture
purchased.
U.S. Patent:436,208
This product is protected by United States Federal and/or
State Law, including Patent and/or Copyright laws.
© 1998 Minka Lighting, Inc.
LA-286E-A