the great outdoors by Minka Lavery 8283-A61 Installation Guide

INSTALLATION INSTRUCTIONS
For Model 8283-A61
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove
old fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the
parts on
a clear area. Take care not to lose any
small parts necessary for installation.
3. Attach the Crossbar (A) to the outlet box using the two
screws (B) from the outlet box. The side of the
Crossbar (A) marked “GND” must face out.
4. Thread the Nipple (C) Part Way into the center hole of
the Crossbar (A).
Fig. 1
E
D
A
C
B
CONNECTING ELECTRICAL (Fig.2)
5. At this point,Connect the electric wires as shown in Fig
2. marking sure that all wire nuts are secured. You may
have to wrap the connections with electrical tape. If
your outlet box has a ground wire (green or bare
copper), connect the fixture ground wire to it,
otherwise, connect the fixture ground wire directly to
the crossbar using the green screw provided.
COMPLETING THE INSTALLATION
6. After wires are connected, tuck them carefully inside
the junction box as you place the Fixture Body (C)
over the Nipple. Secure the Fixture Body (C) against
the wall using the knurled Nut (E). (Fig.1).
7. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (ie.Indoor
/Outdoor Silicone Sealant) to outline the outside of
fixture backplane where it meets the wall leaving a
space at bottom to allow moisture a means to escape
(Fig.3)
8. Install 1*60W A19 bulb (not included) to socket in
accordance with the fixture’s specification. (DO NOT
EXCEED THE SPECIFIED WATTAGE!)
Fig. 3
Your installation is now complete. Return power to
the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-1999E
Caulking
Backplate