the great outdoors by Minka Lavery 72173-189 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72172/72173-189
READ AND SAVE THESE INSTRUCTIONS
WARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off power at the circuit breaker and remove the old fixture,
including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any parts necessary for
installation.
3. Thread the two studs (S) into the pre-drilled holes in the
mounting plate (M) spaced the same distance apart as the
holes in the back plate (U). Note: The length of studs (S) into
mounting plate (M) may be adjusted if necessary.
4. Attach the mounting plate (M) (Part#A-020) to the outlet box
(not provided) with screws (C) (Size: 8-32*1/4”).
5. Align the curved end of scroll arm (R) through the decorative
ring (T) and secure the other end to the back plate (U) with
screw (Q) (Size: M4*10), hex nut and washer (P).
Fig.1
CONNECTING ELECTRICAL (Fig.2)
6. Connect the electrical wires as shown in (Fig.2), making sure
that all wire connectors are secured. If your outlet has a ground
wire (green or bare copper), connect the fixture ground wire to
it. Otherwise, connect the fixture ground wire directly to the
mounting plate using the green screw provided.
7. Align the fixture to the mounting studs (S) (Size: 8-32*1/2”) on
and secure with knurled knobs (B) and washers (K)(Fig1).
8. To prevent moisture from entering the outlet box and causing a
short, use clear caulking (i.e. Indoor/Outdoor Silicone Sealant)
to outline the outside off fixture back-plate where it meets the
wall leaving a space at bottom to allow moisture a means to
escape (Fig3).
COMPLETING THE INSTALLATION
9. Separate lamp body (O) from top cover (H) by unscrewing the
mounting screws (G) (Size: M4*16). Align the glass (E) into
body (O) and secure with glass clips (F).
10. Place candle sleeves (V) over the sockets (W).
11. Install the 3*60W (part#:72172) & 4*60W (part#:72173) light
bulbs (D) in accordance with the fixtures specification. (DO
NOT EXCEED THE MAXIMUM WATTAGE
RATING!)(NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
12. Re-attach body (O) to the top cover (H) with mounting screws
(G).
Your installation is now complete. Return power to the junction
box and test the fixture.
“CAUTION-RISK OF FIRE CONSULT A QUALIFIED
ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR”
ATTENTION
–
RISQUE
D’INCENDIE,
CONSULTER
UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE LES
CONDUCTEURS DE LA DÉRIVATION SONT ADÉQUATS.
Fig.3
Set A#: A-020-1
-Mounting plate
-Ground screw
-Mounting screws(2)