the great outdoors by Minka Lavery 8267-66-L Instructions / Assembly

INSTALLATION INSTRUCTIONS
Model # 8267-L
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
Fig.1
1. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clear area. Take care not to misplace any small parts
necessary for installation.
3. Thread the two studs (B) into the pre-drilled holes in the
circular strap (C) spaced the same distance apart as the
holes in the back plate.
4. Attach the circular strap (C) using outlet box screws (F) to
the outlet box (A) (not supplied), the side of the marked
"GND" must face out (Fig 1).
D
CBA
H
E
GF
I
J
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig.2. Making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the cross bar using the
green screw (D) provided.
FINISHING THE INSTALLATION (Fig. 1)
6. Align the back plate onto studs (B) and secure with cap
nut (G) (Fig 1).
7. To prevent moisture from entering the outlet box (A) (not
supplied) and causing a short, use clear silicone sealant
to outline the outside of fixture back plate where it meets
the wall leaving a space at bottom to allow moisture a
means to escape (Fig. 3)
8. Install glass panels (P) via the bottom of the cage (J) and
secure with the glass clips provided.
9. Bulb (H) information (1 x AC LED 10W included.)
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING) (NE PAS DEPASSER LA PUISSANCE
P
F ig.2
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
FIXTURE
WIRES
WHITE
FIXTURE
WIRES
BLACK
HOUSE
WIRES
BLACK
(HOT)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)
HOUSE
WIRES
WHITE
(NEUTRAL)
Fig. 3
NOMINALE MAXIMALE!)
10. Replacing LED module (Fig.4)
11.
The LED module can be replaced by a qualified
electrician without cutting of wire and without damage to any
decorative element to which the fixture is attached. See
installation steps for more details (Fig.4).
a. Shut off power, take out and unplug the male and female
jacket M&N via the bottom of the cage (J).
b. b. Loosening module screws (I) and carefully remove LED
module (H) for re-lamping. Note: The LED module should
be provided by a specified supplier.
c. For better heat dissipation the LED module (H) should be
installed with the heat transfer material (O) when relamping.
(
Caulking
Backplate
)
Fig. 4
N (Female Jacket)
Your installation is now complete. Return power to the
outlet box and test the fixture.
Aluminum Panel
M (Male Jacket)
L (Glass)
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
K (Module Ring)
O (Graphite Sheet)
H (LED Module)
I (Module Screws)