the great outdoors by Minka Lavery 9276-277 Instructions / Assembly

INSTALLATION INSTRUCTIONS
Model # 9276-277
READ AND SAVE THESE INSTRUCTIONS
WARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clear area. Take care not to misplace any small parts
necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Connect electrical wires while supporting the lantern. If
your post has a ground wire (green or bare copper),
connect the fixture ground wire to it. If not, consult your
electrician for proper grounding. After wires are
connected, tuck them carefully inside the post cup (I).
Align the lantern with post (L) and secure with screws (J).
(Fig.1&2)
COMPLETIG THE INSTALLATION (Fig. 1)
4. Fix the glass (F) to lamp frame (D) with glass retainer
clips (G),
5. Revolve the centre rod (E) till to firmly
6. Install the 3*60w B10.5 light bulbs in accordance with the
fixture specification. DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!.
7. Align cover (C) centre rod (E) and secure with rubber
washers (B) and finial (A)
Your installation is now complete. Return power to and test
the fixture.
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
Fig.2
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
FIXTURE
WIRES
WHITE
FIXTURE
WIRES
BLACK
HOUSE
WIRES
BLACK
(HOT)
HOUSE
WIRES
WHITE
(NEUTRAL)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)
Fig. 1