Design House 154088 Instructions / Assembly

CEILING FAN REMOTE CONTROLLER
OPERATION AND INSTALLATION INSTRUCTIONS
(Please keep this instruction pamphlet.)
IMPORTANT
YOU MUST SET CEILING FAN TO HIGH SPEED AND LIGHT KIT (IF ANY)
TO BE ON POSITION BEFORE OPERATING REMOTE CONTROL.
THE LIGHT WILL BE TURNED ON ONCE AC POWER CONNECTED.
IMPORTANT POINTS TO REMEMBER:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Read and save these instructions.
Please note that all fixed wiring appliances should be installed by a qualified electrician.
The supply to the remote control receiver should be connected through a main switch, i.e. existing wall switch.
Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.
Install receiver into the ceiling fan canopy to ensure proper protection (see page 2).
This unit is to be used for the control of ceiling fan in a AC110/120V 60Hz power supply only.
Do not pull on or cut leads shorter.
Do not drop or bump the unit.
PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place as this
will damage the transmitter. Dispose of used battery properly; keep the battery out of reach of children.
CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable (rheostat)
wall control.
CODE SWITCH
1. CODE SWITCH: Codes are set by pushing dip switches up or down. It is imperative that the code used for both
transmitter and receiver is exactly the same; otherwise remote controller will not work. Please note the code switch will
enable you to operate a second remote controller independently. For example, if you have two ceiling fans with 2 remote
control units, set 2 different codes for each set of transmitter/receivers. This means you can operate each ceiling fan
independently.
2. Your remote control is ready for use after battery installation.
Requires one 9-Volt battery.
TO OPEN BATTERY HOUSING COVER
BY PRESS DOWN AND SLIDE OUT
DIP SWITCH
RECEIVER
ANTENNA
TRANSMITTER
FUNCTIONS OF TRANSMITTER
OFF
: Turn off the ceiling fan.
HI
: Turn on the fan at high speed
MED
: Turn on the fan at medium speed
LOW
: Turn on the fan at low speed
LIGHT DIM: The LIGHT DIM button will control the light brightness
The light function is controlled by pressing the button. Hold button down to
increase or decrease light .Tap button quickly to turn light off or on .
if you press the button in excess of 0.7 second it become a dimmer .
(Only use incandescent bulbs)
Ceiling Fan Remote Control
Wiring Connection
BLACK
RED
ANTENNA
WHITE
AC POWER
FAN MOTOR
INPUT
Installation of Transmitter Wall
Mount Holder with two screw.
ANTENNA
INSTALLATION INSTRUCTIONS
CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.
1. Ceiling fan must be set a HIGH speed and light kit (if any) at ON position by pulling the “Pull Switch” after
installation.
2. Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy comes
up to cover the receiver and bracket.
ANTENNA
AC POWER SUPPLY
(Leave unconnected and do not cut)
BLACK
(Mains/Live)
BLUE
(Light/Live)
WHITE
(Fan/Light/Neutral)
BLACK
(Fan/Live)
WHITE
(Mains/Neutral)
ANTENNA
BLACK