AireRyder LK38812OL Instructions / Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
LK38812
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless
additional support is provided for the fan.
Motor
Black or Blue Wire
Wire Nut
Black Wire
Switch Box
White Wire
White Wire
Hex Nut & Washer
Switch Box Screw
Center Plug
Switch Box Cover
Nipple(-a)
Top Cap
Socket Set
Cap
Nipple(-b)
Pull Chain
For Light Kit:
1. Remove the switch box cover from the
switch box of the fan by loosing the
Glass Shade
three switch box screws.
2. Unscrew the center plug from the switch
box cover and discard it.
Metal Ring
3. Thread the fixture wire through the switch
box cover.
Finial
4. Attach nipple(-a) of the light kit to the switch
box cover, then secure it with a washer and
hex nut.
5. Cut the redundant wires if necessary. Pull out the wires from the switch box. Make wire connections
using the wire nuts:
---The black wire from the fixture to the black (or blue) wire from the switch box.
---The white wire from the fixture to the white wire from the switch box.
Carefully tuck the wires back into the switch box.
6. Attach the switch box cover back to the switch box using the three switch box screws.
7. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
8. Thread the pull chain through the glass shade, metal ring and finial. Carefully attach the glass shade
and the metal ring to the cap by inserting nipple(-b), then secure them with the finial.
9. Turn on the power at the main fuse or circuit breaker box. (You can control the light with the pull chain.)
TM
LK38812 --- Page 1
060301
For Ceiling Light: (See Fig.1)
1. Take out a hex nut, washer, grounding pad and canopy
Mounting Parts for Ceiling Light
from the hardware package for ceiling light.
2. Attach the canopy with the open side facing upward to the
Outlet Box
top cap by inserting nipple(-a), then secure it with a washer,
House Grounding Wire
grounding pad and hex nut.
Wire Nut
3. Attach two screws to the mounting strap, then secure
Screw
them with two lock nuts. Adjust the length of the screws
Mounting Strap
if necessary.
Lock Nut
4. Attach the mounting strap to the outlet box by using two
Green Grounding Screw
Mounting Screw
mounting screws.
Fixture
Grounding Wire
5. Pull out the outlet wires and the house grounding wire
Hex Nut
from the outlet box. Make wire connections using the wire
Grounding Pad
Washer
nuts:
Canopy
---The black wire from the fixture to the black wire from the
Nipple(-a)
outlet box.
Top Cap
---The white wire from the fixture to the white wire from the
Bolt Nut
Fixture
outlet box.
Fig.1
---Attach the fixture grounding wire to the mounting strap
with the green grounding screw. Then connect it to the house grounding wire with a wire nut.
Carefully tuck the wires back into the outlet box.
6. Attach the canopy to the mounting strap by inserting two screws, then secure it with the bolt nuts.
7. Follow steps 7~9 as for Light Kit.
TM
LK38812--- Page 2
060301