Kenroy Home 60508 Installation Guide

60508
ASSEMBLY INSTRUCTIONS
MODEL:
READ AND SAVE THESE INSTRUCTIONS
3.) Slide the LED light body through the
bottom of your deck.
READ INSTRUCTIONS ALL THE WAY THROUGH
PRIOR TO ASSEMBLY.
Assembly Time: 10 Minutes.
IMPORTANT NOTES:
The led light string need to be connected with
60507 (sold separated).
UNPACK THE LED LIGHT STRING
The following parts should be included in your
LED light kits; (10) LED Lights.
TOOLS
A drill will be required for deck or hard surface
installation.
DECK INSTALLATION
1.) Using your drill with the spade bit,
carefully drill through your deck, keep drilling
until the flag touches the deck's surface.
4.) Once through the hole, screw the lens to the
body.
5.) Drop in place.
GROUND INSTALLATION
Bury the LED Light String bodies in grass,
mulch, or gravel. You may wish to create a small
trench between lights in order to conceal the
cable.
2.) Remove the lens from the body.
TIP:
Use your drill and the included spade bit for
greater precision.
60508
ASSEMBLY INSTRUCTIONS
MODEL:
READ AND SAVE THESE INSTRUCTIONS
FINAL ASSEMBLY
1.) Remove the cap from the connector of 60507, then join the connectors and screw the cap
tightly together.
2.) Plug transformer into socket and press the switch, your LED Light String is ready for use.
3.) The LED Light String will turn on automatically at dusk.
4.) The LED Light String accepts expansion accessories 60508 (10 light extra string) and 60509
(12' length extender cord) (sold separated).
Note: The maximum limit of transformer is carry 3 piece light strings only.
TROUBLE SHOOTING:
1.) If your LED Light is not functioning properly or losing power mid-cycle, Check your
connections to the tranformer - a loose or improperly connected cable will cause the LED Light
String to malfunction.
2.) The led light will turn on automatically every night.