Laura Ashley HAME0855 Instructions / Assembly

Assembly Instructions
Aimee Chandelier # HAME0855
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
1. Attach nipple(-a) to the mounting strap, then secure it with a
Note: Spare crystal
washer and hex nut.
drops are enclosed
2. Attach the mounting strap to the outlet box by using two
in hardware bag.
mounting screws.
3. Carefully thread the wires through the upper fixture and loop,
screw the upper fixture onto nipple(-c) securely.
2
3
1
4. Secure the loop onto nipple(-b).
(3) PCS. (3) PCS. (15) PCS.
5. Adjust the arms of the fixture according to the drawing of the
package.
Outlet Box
Important:
House Grounding Wire
a. The arms should be positioned with equal distances
Wire Nut
between them.
Hex Nut
Washer
b. The arms should be fixed securely.
Mounting Strap
6. Choose the length of the chain you need, then weave the fixture
Green Grounding Screw
wire and the fixture grounding wire through the chain. Then
Mounting Screw
Nipple(-a)
connect one end of the chain with the loop by using the loop lock.
7. Secure the top loop to nipple(-a) tightly.
Canopy
8. Thread the fixture wire and fixture grounding wire through the
collar, canopy, top loop, nipple(-a) and mounting strap.
Top Loop
9. Connect the other end of the chain with the top loop by using the
Collar
loop lock.
Loop Lock
10. Pull out the outlet wires and house grounding wire from the outlet
Fixture Grounding
box. Make wire connections with wire nuts:
Wire
---The smooth wire (marked) from the fixture to the black wire
Chain
from the power source.
Loop Lock
---The ridged wire (unmarked) from the fixture to the white wire
Fixture Wire
from the power source.
Loop
---Attach the fixture grounding wire to the mounting strap with
Nipple(-b)
the green grounding screw. Then connect it to the house
Upper Fixture
grounding wire with the wire nut.
Socket
Carefully put the wires back into the outlet box.
Candle Cover
11. Attach the canopy to the mounting strap by inserting the top
Glass Cap
loop, then secure it with the collar.
12. Attach a rubber pad, glass holder and decorative cap to the
2
holder by inserting nipple(-d), then secure them with the finial.
1
13. Attach the candle covers and glass caps onto the sockets,
then install bulbs (not included). See relamping label at
Nipple(-c)
socket area or packaging for maximum allowed wattage.
Arm
14. Install the crystal drops and pearl strands as shown in
diagram.
Note: To replace broken crystal drops -Open the pins
to remove the crystal drops, hook the new crystal drops,
and then close back pins. Avoid bending the pins into
sharp angle.
3
15. Turn on the power at the main fuse or circuit
Holder
3
breaker box.
Nipple(-d)
Rubber Pad
Glass Holder
Decorative Cap
Finial
3
Pearl Strand